DAVIS Hldz It User Manual

#262

ELECTRONICS DEVICE HOLDER

INSTRUCTIONS

ASSEMBLY: Slide mounting plate into the groove in the
instrument cradle (drawing A).

MOUNTING OPTIONS:

• Suction Cups. Insert threaded stud through holes in
mounting plate and secure brass nuts (B).

• Velcro

®

Patch. Peel backing tape off self-adhesive patch
and affix to back of mounting plate (C). Stick mating
piece of Velcro in desired location.

• Screws. Drill holes in desired surface using 3 mm drill bit. Attach mounting plate
using the two stainless steel screws provided (D).

INSTRUMENT ATTACHMENT OPTIONS:

• Velcro

®

Strap. Feed Velcro strap through the slats in the instrument cradle (E) until

centered (F). Secure the ends of the strap around your electronic unit.

• Shock Cord. Feed shock cord through the slats in the instrument cradle as shown (G).
Pull the two ends of the cord through the coupler until desired tension is obtained.
Tie knots in the cord ends and press into coupler.

• Velcro

®

Patch. If the patch was not used as a mounting option, it may be used for
securing electronics to the instrument cradle. Adhere the patch to the cradle (H), and
the mating piece to the back of your electronic device.

REPLACEMENT PARTS:

Contact your dealer or Davis Instruments for replacement parts.

R262A Mounting Hardware: adhesive Velcro, Velcro strap, suc-

tion cups (2), stainless steel screws (2).

R262B Rear Plastic Mounting Plate.

3465 Diablo Avenue, Hayward, CA 94545, U.S.A.

Phone [phone] • Fax [phone]

[e-mail] • www.davisnet.com

262_Engl.pdf October 2005