DAVIS EchoMaster Surface Mount Kit User Manual

Assembly Instructions

1. Note numbers and arrows stamped on reflector plates. Slide Full Circle Plates (1 and 2) together as shown.

Hold together by snapping on plastic Corner Latches at the top and bottom.

2. Slide Half Plate (3) into position as shown. Snap a Corner Latch at its center.

3. Slide the remaining Half Plate in place (reversing it if the Corner Latches do not match).

4. Snap the three remaining Corner Latches to secure the Half Plates. The Reflector is now assembled.

5. Install Mounting Base by through-bolting to a flat surface or U-bolting to a rail. Hardware not included. Use #10

to 1/4" (5–6mm) through bolts for surface mounting. Contact a professional installer if through-bolting is
not possible. Use 1-1/2" (38 mm) U-bolts for rail mounting. Maximum rail diameter 1-1/4" (32 mm).

6. Insert Tube into Base and secure with machine screw, washers and nut supplied. Install Cotter Pin in middle
hole of Tube.

7. Slip Spring, Flat Washer, and a Corner Block onto Tube.

8. Slide Reflector Assembly over Tube, with Corner Block fitting into any corner.

9. Slip second Corner Block and Flat Washer onto Tube. Push down to compress spring, then secure with sec-

ond Cotter Pin. Push Cap onto end of Tube.

#157 SURFACE MOUNT SYSTEM