Page 1
Inductive sensor NCB50-FP-E34-C-P3-V1
Dimensions
Model Number
NCB50-FP-E34-C-P3-V1
Features
• 50 mm flush
•4-wire DC
• Weld Immune
• Optimum use at a distance >50 cm
Connection
1
4
3
L+
L-
Pinout
1
2
Wire colors in accordance with EN 60947-5-2
1 BN
2 WH
3 BU
4 BK
(brown)
(white)
(blue)
(black)
4
3
15
40
M12 x 1
10 22
84
65
65
LEDs
Technical Data
General specifications
Switching element function PNP NC
Rated operating distance s
Installation flush
Output polarity DC
Assured operating distance sa0 ... 40.5 mm
Reduction factor r
Reduction factor rCu 0.35
Reduction factor r
Nominal ratings
Operating voltage UB10 ... 60 V DC
Switching frequency f 0 ... 1 Hz
Hysteresis H typ. 3 %
Reverse polarity protection reverse polarity protected
Short-circuit protection pulsing
Voltage drop Ud≤ 3 V
Operating current I
Off-state current I
No-load supply current I
Time delay before availability t
Tuning-out ≥ 50 ms
Operating voltage display LED, green
Switching state indication LED, yellow
Ambient conditions
Ambient temperature -25 ... 70 °C (-13 ... 158 °F)
Mechanical specifications
Connection type Connector M12 x 1 , 4-pin
Housing material PBT/metal
Sensing face PBT, active surface PTFE coated
Housing base metal
Protection degree IP68
Mass 530 g
Compliance with standards and directives
Standard conformity
Standards
Approvals and certificates
UL approval cULus Listed, General Purpose
CSA approval cCSAus Listed, General Purpose
0.38
Al
0.83
304
50 mm
n
0 ... 200 mA
L
0 ... 0.5 mA
r
≤ 20 mA
0
≤ 1 s
v
EN 60947-5-2:2007
IEC 60947-5-2:2007
ø 9.5
7
ø 5.3
Release date: 2013-04-05 16:37 Date of issue: 2013-04-08 188778_eng.xml
Subject to modifications without notice
Copyright Pepperl+Fuchs
1
Page 2
Inductive sensor NCB50-FP-E34-C-P3-V1
Installation hint
These sensors are especially
designed for embeddable mounting in
conveyor floors. Due to its precise
location in metal base plates the
sensor is afforded a high degree of
mechanical protection. No clearance
is required between the sensor and
the base plate, avoiding the need for
protective guarding to prevent
possible foot injury.
The large sensing range ensures
positive detection, and thus provides
consistent control and monitoring of
the conveyor.
>95mm
Warning!
Once the metal screening has been
removed, the sensor can no longer be
mounted.embeddable
Release date: 2013-04-05 16:37 Date of issue: 2013-04-08 188778_eng.xml
Subject to modifications without notice
Copyright Pepperl+Fuchs
2
Loading...