Datasheet HA17904FPK, HA17904FP, HA17904PSJ, HA17904PS, HA17358F Datasheet (HIT)

...
Page 1
HA17358, HA17904 Series
Dual Operational Amplifier
Description
HA17904 and HA17358 are dual operational amplifiers which, provide internal phase compensation and high gain, and mono power source operation is possible. It can be widely applied to control equipment and to general use.
Features
Wide range of operating supply voltage and mono power source operation is possible.
around 0V is available.
Frequency characteristics and input bias currrent are temperature compensated.
Ordering Information
Type No. Application Package
HA17904PSJ Car use DP-8 HA17904FPJ Car use FP-8D HA17904FPK Car use HA17904PS Industrial use DP-8 HA17904FP Industrial use FP-8D HA17358 Commercial use DP-8 HA17358F Commercial use FP-8D
Page 2
HA17358, HA17904 Series
Pin Arrangement
Circuit Schematic (1/2)
Vin(–)
Vin(+)
Q1 Q4
Vout1
Vin(–)1
Vin(+)1
GND
Q2 Q3
Q8 Q9
1
2
3
4
1
–+
(Top View)
C
Q10
2
+–
Q11
8
7
6
5
Q12
V
CC
Vout2
Vin(–)2
Vin(+)2
Q7
Q5
Q6
Q13
1
R
Vout
2
Page 3
HA17358, HA17904 Series
Absolute Maximum Ratings (Ta = 25°C)
Ratings
HA17358 HA17358FHA17904PSHA17904FPHA17904
Item Symbol
Supply
V
CC
32 32 32 32 32 32 32 V
PSJ
voltage Output sink
I
O sink
50 50 50 50 50 50 50 mA
current Common-
mode input
V
CM
–0.3 to V
CC
–0.3 to V
CC
–0.3 to V
CC
–0.3 to V
CC
–0.3 to V
CC
voltage Common-
V
IN(diff)
±V
CC
±V
CC
±V
CC
±V
CC
±V
CC
mode differential voltage
Power
P
T
570*
1
385*
2
570*
1
385*
2
570*
dissipation Operating
temperature
Topr –20 to
+75
–20 to +75
–20 to +75
–20 to +75
–40 to +85
range Storage
temperature
Tstg –55 to
+125
–55 to +125
–55 to +125
–55 to +125
–55 to +125
range Notes: 1. These are the allowable values up to Ta = 55 °C. Derate by 8.3mW/°C above that temperature.
2. These are the allowable values up to Ta = 45 °C mounting on 30% wiring density glass epoxy board. Derate by 7.14mW/°C above that temeperature.
HA17904 FPJ
–0.3 to V
CC
±V
CC
1
385*
–40 to +85
–55 to +125
HA17904 FPK Unit
–0.3 to V
±V
2
385*
–40 to +125
–55 to +150
CC
CC
2
V
V
mW
°C
°C
3
Page 4
HA17358, HA17904 Series
Electrical Characteristics 1 (VCC = +15V, Ta = 25°C)
Item Symbol Min Typ Max Unit Test Conditions
Input offset voltage V Input offset current I Input bias current I Power source rejection
IO
IO
IB
PSRR 93 dB RS = 1k, Rf = 100k
—3 7 mVV — 5 50 nA VCM = 7.5V, IIO = | I — 30 250 nA VCM = 7.5V
ratio Voltage gain A Common mode rejection
VD
CMR 80 dB RS = 50Ω, Rf = 5k
75 90 dB RL = , RS = 1kΩ, Rf = 100kΩ
ratio Common mode input
V
CM (+)
13.5 V RS = 1k, Rf = 100k
voltage range
Peak-to-peak output
V
CM (–)
Vop-p 13.6 V f = 100Hz, RL = 20k, RS = 1k,
–0.3 V RS = 1k, Rf = 100k
voltage Output source current Iosource 20 40 mA V Output sink current Iosink 10 20 mA V Output sink current Iosink 15 50 µAV
Supply current I
CC
0.8 2 mA VIN = GND, RL = Slew rate SR 0.2 V/µsRL = , VCM = 7.5V, f = 1.5kHz Channel separation CS 120 dB f = 1kHz
Note: As for the characteristic curve, refer to HA17902.
= 7.5V, RS = 50Ω, Rf = 50k
CM
– I
I (+)
I (–)
Rf = 100k
+
= 1V, V
IN
= 1V, V
IN
= 1V, V
IN
= 0V, VOH = 10V
IN
+
= 0V, VOL = 2.5V
IN
+
= 0V,
IN
Vout = 200mV
|
Electrical Characteristics 2 (VCC = +15V, Ta =40 to +125°C)
Item Symbol Min Typ Max Unit Test Conditions
Input offset voltage V Input offset current I Input bias current I Common mode input
IO
IO
IB
V
CM
——7 mVV
200 nA VCM = 7.5V, IIO = | I
500 nA VCM = 7.5V
0 13.0 V RS = 1k, Rf = 100k voltage range
Supply current I
CC
——4 mAV Note: As for the characteristic curve, refer to HA17904FPK.
4
= 7.5V, RS = 50Ω, RL = 50k
CM
= GND, RL =
IN
I (+)
– I
I (–)
|
Page 5
Package Dimensions
1.27
4.85
5.25 Max
8
1
0.75 Max
HA17358, HA17904 Series
Unit: mm
5
4.4
4
+ 0.25
6.50
– 0.15
2.03 Max *0.22 ± 0.05
0.20 ± 0.04
0.60
1.05
+ 0.25 – 0.18
0° – 8°
*0.42 ± 0.08
0.40 ± 0.06
*Dimension including the plating thickness
Base material dimension
4.85
5.25 Max
8
1
0.75 Max
1.27
0.10 ± 0.10
0.15
M
0.12
Hitachi Code JEDEC EIAJ
(reference value)
Mass
FP-8D — Conforms
0.10 g
Unit: mm
5
4.4
4
+ 0.25
6.50
– 0.15
2.03 Max *0.22 ± 0.05
1.05
0.20 ± 0.04
0° – 8°
+ 0.25
0.60
– 0.18
*0.42 ± 0.08
0.40 ± 0.06
*Dimension including the plating thickness
Base material dimension
0.10 ± 0.10
0.12
0.15
M
Hitachi Code JEDEC EIAJ
(reference value)
Mass
FP-8D — Conforms
0.10 g
5
Page 6
HA17358, HA17904 Series
Cautions
1. Hitachi neither warrants nor grants licenses of any rights of Hitachi’s or any third party’s patent, copyright, trademark, or other intellectual property rights for information contained in this document. Hitachi bears no responsibility for problems that may arise with third party’s rights, including intellectual property rights, in connection with use of the information contained in this document.
2. Products and product specifications may be subject to change without notice. Confirm that you have received the latest product standards or specifications before final design, purchase or use.
3. Hitachi makes every attempt to ensure that its products are of high quality and reliability. However, contact Hitachi’s sales office before using the product in an application that demands especially high quality and reliability or where its failure or malfunction may directly threaten human life or cause risk of bodily injury, such as aerospace, aeronautics, nuclear power, combustion control, transportation, traffic, safety equipment or medical equipment for life support.
4. Design your application so that the product is used within the ranges guaranteed by Hitachi particularly for maximum rating, operating supply voltage range, heat radiation characteristics, installation conditions and other characteristics. Hitachi bears no responsibility for failure or damage when used beyond the guaranteed ranges. Even within the guaranteed ranges, consider normally foreseeable failure rates or failure modes in semiconductor devices and employ systemic measures such as fail­safes, so that the equipment incorporating Hitachi product does not cause bodily injury, fire or other consequential damage due to operation of the Hitachi product.
5. This product is not designed to be radiation resistant.
6. No one is permitted to reproduce or duplicate, in any form, the whole or part of this document without written approval from Hitachi.
7. Contact Hitachi’s sales office for any questions regarding this document or Hitachi semiconductor products.
Hitachi, Ltd.
Semiconductor & Integrated Circuits. Nippon Bldg., 2-6-2, Ohte-machi, Chiyoda-ku, Tokyo 100-0004, Japan Tel: Tokyo (03) 3270-2111 Fax: (03) 3270-5109
URL NorthAmerica : http:semiconductor.hitachi.com/
For further information write to:
Hitachi Semiconductor (America) Inc. 179 East Tasman Drive, San Jose,CA 95134 Tel: <1> (408) 433-1990 Fax: <1>(408) 433-0223
Europe : http://www.hitachi-eu.com/hel/ecg Asia (Singapore) : http://www.has.hitachi.com.sg/grp3/sicd/index.htm Asia (Taiwan) : http://www.hitachi.com.tw/E/Product/SICD_Frame.htm Asia (HongKong) : http://www.hitachi.com.hk/eng/bo/grp3/index.htm Japan : http://www.hitachi.co.jp/Sicd/indx.htm
Hitachi Europe GmbH Electronic components Group Dornacher Straβe 3 D-85622 Feldkirchen, Munich Germany Tel: <49> (89) 9 9180-0 Fax: <49> (89) 9 29 30 00
Hitachi Europe Ltd. Electronic Components Group. Whitebrook Park Lower Cookham Road Maidenhead Berkshire SL6 8YA, United Kingdom Tel: <44> (1628) 585000 Fax: <44> (1628) 778322
Hitachi Asia Pte. Ltd. 16 Collyer Quay #20-00 Hitachi Tower Singapore 049318 Tel: 535-2100 Fax: 535-1533
Hitachi Asia Ltd. Taipei Branch Office 3F, Hung Kuo Building. No.167, Tun-Hwa North Road, Taipei (105) Tel: <886> (2) 2718-3666 Fax: <886> (2) 2718-8180
Copyright ' Hitachi, Ltd., 1998. All rights reserved. Printed in Japan.
6
Hitachi Asia (Hong Kong) Ltd. Group III (Electronic Components) 7/F., North Tower, World Finance Centre, Harbour City, Canton Road, Tsim Sha Tsui, Kowloon, Hong Kong Tel: <852> (2) 735 9218 Fax: <852> (2) 730 0281 Telex: 40815 HITEC HX
Loading...