92-2477-01 Rev.C
Internal Rewinder Option
Contents of the Internal Rewinder Kit
This kit contains the following items:
Arc Plate,
Internal Rewinder Assembly
Media Clip
Media Retainer
Screws (3)
Follow the steps listed below to install this option.
Tools Required
To install this option you will need a #2 Phillips head screwdriver.
Step 1: Preparing the Printer
Turn ‘Off’ the power switch and unplug the
printer.
Open the cover. Remove any installed media
from the printer.
Remove the Fascia by gently pulling it forward.
Loosen and remove the Thumbscrew, then
remove the Tear Plate.
Thumbscrew
Tear Plate
Fascia
1
Remove the three Screws that
secure the Cover Plate to the
printer.
Remove the Cover Plate.
Screws
Step 2: Installing the Internal Rewinder
Carefully position the Internal
Rewinder into the Centerplate of
the printer, as shown.
Secure the Internal Rewinder
using the three Screws supplied
in this kit.
Screws
Step 3: Installing the Arc Plate
Position the Arc Plate onto the front
of the printer, as shown.
Using a #2 Phillips head screwdriver,
secure the Arc Plate to the printer.
This completes the installation process.
Proceed to Media Loading.
Cover Plate
Centerplate
Internal Rewinder
2
Arc Plate
Media Loading
Load media into the printer as you normally would for tear-off operation (see the Operator’s Manual
for details), however, extend an additional 12 inches (30 cm) of media out the front of the printer.
Route the Media over the Arc Plate and around the Internal Rewinder, as shown below.
Media
Media
Slots
Arc Plate
Internal Rewinder
Media Clip
Retainer
Thumbscrew
Note: The Media Retainer can be used in place of the Media Clip for a more consistent rewound roll. The Media
Clip and Media Retainer cannot be used together.
Put the leading edge of the Media into a Slot on the Internal Rewinder and insert the Media Clip. Be
sure the leading edge of the Media is cut square and that is inserted evenly into the slot.
Manually rotate the Internal Rewinder to remove slack from the Media.
Plug in and turn ‘On” the printer. After initialization, press the FEED Button to align the next label to
the top of form position. The printer is now ready to rewind printed labels.
Unloading the Internal Rewinder
When the Internal Rewinder becomes full, remove the Media Clip. Grasp the used media and carefully
pull it from the Internal Rewinder.
Note: Never allow the outer diameter of backing material to exceed 4 inches (102 mm) on the Internal Rewinder.
3
Loading...