Datamax-O'Neil I-Class Mark II GPIO Option User Manual
92-2586-01 Rev.B
GPIO Option
Overview
This document describes the installation and use of the General Purpose Input Output
(GPIO) option for the I-Class Mark II printer. Follow the steps to begin installing/using the
option.
For safety and to avoid equipment damage, turn OFF the power switch and
CAUTION
unplug the AC power cord from the printer before starting this installation.
Contents
This kit contains the following items:
GPIO Circuit Card Assembly
Standoff, 6mm Hex (2)
Locking Nut, 5.5mm (2)
Tools Required
To install this option, you will need:
Philips screwdriver
5mm Hex Driver
5.5mm Hex Driver
6mm Hex Driver
1
2
3
Additional Requirements
Depending on your application, you may need the following hardware to interface the card:
Cable - DB15 Male connector (e.g., StarTech C15PCM) with shielded cabling.
1
Installing the Option
If the GPIO Card is already installed in the printer, skip this section and proceed to
“Configuring the Hardware”. Otherwise, install the GPIO Card as described below:
A) Turn off and disconnect the power cord from the printer. Remove the three Screws
from the left side cover of the printer.
B) Open the printer’s cover, loosen (do not remove) the two Screws on the inside of the
printer and lift the Cover Assembly up and off the printer.
Cover
Assembly
Screws
Screws
2
Loading...