DAS AUDI Systems High MMI 2G, AUDI Systems HighMMI 3G Installation And User Manual

Multiconn Srl

AUDI Systems High MMI 2G – MMI 3G

www.dasdvbt.com

Installation and User Manual ver.1.0

[to integrate with the user manual of DAS M32/M44]

Fiber Optic

MMI 2G – MMI 3G

1. To install the DAS

®

receiver, refer to the specific user manual;

Warning on the connection of the power supply cable:

- RED wire (fig.3) must be DISCONNECTED.
The switch (ON/OFF) of the receiver will be controlled by the Fiber-Optic activity

- YELLOW wire (fig.1) must be connected to the +12V permanent/battery

- BLACK wire (fig.2) must be connected to the GND.

Multiconn Srl

2

Power supply cable

1

2

3

2. Disconnect the original Fiber Optical cable (fig.4) from one of the original multimedia accessories inside the car (DVD, GPS, Amplifier, etc…)

and match it directly to DAS

®

fiber optic female connector of the harness on equipment (fig.5).

4

4 5

MMI2G – MMI3G Installation:

3. Match the two other connectors of DAS® harness (fig.6) respectively inside the original accessory (fig.7) and the other one inside DAS®

receiver (fig.8).

4. Connect one of the 3 DAS

®

Video-OUT (fig.8) trough the adapter cables on equipment (fig.9) and the needed accessory (DCABFK-RCA in

fig.9.1) with the Video-IN located on the original module FBAS (fig.10) or on the Audi Multimedia module (fig.11).

Multiconn Srl

3

7

7 8

6

5

8

9

8

9.1

9

MMI 2G – MMI 3G