Danfoss SpeedUp Heat Panels in Dry Installations Installation guide

Installation Guide

SpeedUp Heat Panels in Dry Installations

1 Installation of SpeedUp Heat Panels in Dry Installations

Fig. 1: Install SpeedUp perimeter insulation and support batten
on dry, even and load bearing substrate.

Fig. 3: Place the SpeedUp heat panels (CZ: pipe distance 250
mm, EZ: pipe distance 125 mm). Fill gaps and unheated areas
with blank panels.

Fig. 2: Following the layout, begin the installation in one
corner with a SpeedUp header panel.

Fig. 4: Snap the pre-scored heat panels as required.

Fig. 5: Light constructions (e.g. laminate/engineered timber or
strongboard constructions laid directly on the heat panels):
rooms > 12 m² glue all perimeter and header panels, rooms <
12 m² glue all panels (recommended).

Danfoss Heating Solutions VICSC302

Fig. 6: Where required cut individual pipe channels using the
SpeedUp hot wire cutter.

1

Installation Guide SpeedUp Heat Panels in Dry Installations

Fig. 7: Support battens in thresholds should be screwed
down.

Fig. 9: Press fittings should only be positioned between two
aluminum sheets and never in curved sections of pipe.

Fig. 8: Holding the pipe in a large curve to avoid tension, press
the composite pipe into the channels. Avoid lifting pipe once
installed in the header panels.

Fig. 10: Cover pipe work in front of manifold with SpeedUp load
bearing steel to protect against damage.

Danfoss A/S
Heating Solutions
Haarupvaenget 11
8600 Silkeborg
Denmark
Phone:[phone]
Fax: [phone]
Email: [e-mail]
www.heating.danfoss.com

Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products
already on order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks in this material are property of the respective
companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.

VICSC302 Produced by Danfoss Heating Solutions © 11/2010