Danfoss Reflect Fact sheet

DANFOSS Reflect

Heat Insulation Plates

Now it has become even easier to install It cannot get any simpler, faster or cleaner…
electrical floor heating under laminate and
engineered wooden floors. The Danfoss Reflect insulation plates consist of

a 1/2” thick polystyrene insulation covered with
With Danfoss Reflect there’s no need not worry a thin specially profiled aluminum. The plates
about embedding the heating cables in a mud ensure good downward insulation and
base. Simply lay the insulation plates on the optimum upward heat distribution.
existing floor, press the heating cable into place,
lay the wooden laminate floor directly on top,
connect the thermostat, and you can turn on
the heat!

BRINGING WARMTH TO LIFE

www.LX.Danfoss.com Fax: [phone]Toll Free: 1 866 676-8062

Clean, Simple and Fast Installation...

1

Lay out the Reflect
plates.

4

Cut a groove in the
Reflect plate to allow the
sensor cable to touch the
subfloor. Install the flex
pipe from the thermostat
in the groove. Push the
cold lead of the heating
able from the floor up
into the wall until it
reaches the thermostat.

2

The Reflect plates
should cover the
entire floor area.
Adjust the Reflect
plates to match
the shape of any
corners, oblique
angles, etc. using
a standard jigsaw.

5

Install the heating
cable by lightly
pressing it into the
cable groove.

3

Lock the Reflect
plates together
using the locking
keys supplied.

6

Cover the finished Reflect
floor and heating cables
with noise absorbing
material and install the
wooden laminate
floor on top. Finally
connect the heating
cable and sensor to
the thermostat and
the thermostat to
the main power.

Benefits

Best solution available for heating under laminate and engineered wood flooring
Save time, no mixing thin set or mud required
Reflective plates heat quickly and evenly for maximum comfort
High R Value insulation significantly reduces energy consumption
Exceptional for concrete floors, especially basement renovations
Accepts Danfoss LX and TX heating cables

Technical data

Plate Size 19¾” (50 cm) X 39 ” (100cm), approx. 5.4 sq. feet (.5m )
Part # 088L0096 10 Plates, total 54 sq. feet
Part # 088L0095 4 Plates, total 21.5 sq. feet

½

(5m )

(2m )

2

2

Insulation Value (R): 1.5
Thickness: ½” (13mm)
Deformation strength: 734lbs/sq. foot (3.67 tonnes/

m )

2

Accessories in the box: Locking keys

Danfoss Inc.

Toronto
Toll Free: 1 866 676-8062
Fax: [phone]
www.LX.Danfoss.com

2

Copyright 2009 Danfoss Inc.

NA.EFHSS.REFLECT