Danfoss Power Connection Kit Data sheet

Data Sheet Power Connection Kit

Cable to Junction Box with ½“ NPT cable gland

General
Information

Ordering Information

Technical Data

Kit Contents &
Typical Application

Danfoss heat shrink connection technology
for use with a ½” NPT thread junction box and the fol­lowing self-regulating trace heaters:

• Danfoss PX Pipe Trace Heating System

• Danfoss RX-C Roof and Gutter De-Icing System

To connect the trace heater to the cold lead cable the 2
bus wires are insulated with heat shrink tubes, then con­nected to the cold lead cable inside the junction box.
Additionally, a green/yellow heat shrink tube is provided
to connect the twisted grounding braid to the ground­ing conductor. The connection kit also contains parts for
one end termination for the trace heater.

Part No. Description For Use With

088L0023

Ambient Temperature Range: -4°F to +185°F/ -20°C to +85°C
Max. operating temperature end cap 185°F/ 85°C

Power connection kit (cable to junction

box with ½“ NPT cable gland)

PX Pipe Trace Heating Systems

RX-C Roof & Gutter De-Icing System

*Note: Junction box not
supplied in kit.

Technical
Services

Danfoss can accept no responsibility for possible errors in catalogs, brochures, other printed materials, and website information. Danfoss reserves the right to alter its products without notice.

This also applies to products already on order provided that such alteration can be made without subsequent changes being necessary in specications already agreed upon. All trademarks
in this material are property of the respective companies. Danfoss and Danfoss logotype are trademarks of Danfoss A/S. All rights

© Copyright 2017 Danfoss .11/17 TEL: [phone], FAX: [phone] 2

For technical questions, please contact Danfoss Heating Division North America at 1-888-326-3677
(option 3). More information on Danfoss Electric Heating products is available at LX.Danfoss.com.

reserved.

Danfoss

Toll Free: 1-888-326-3677
Fax: [phone]
www.LX.Danfoss.com