Danfoss PL35G Data sheet

PL35G
Universal Compressor
R134a
220-240V 50/60Hz

General

Code number 101G0251

Approvals UL984, EN 60335-2-34

Compressors on pallet 150

Application

Application MBP/HBP

Frequency Hz 50 60

Evaporating temperature °C -25 to 15 -25 to 0

Voltage range V 198 - 254 198 - 254

Max. condensing temperature continuous (short) °C 60 (70) 60 (70)

Max. winding temperature continuous (short) °C 125 (135) 125 (135)

Cooling requirements

Frequency Hz 50 60

Application

32°C – F2F2– F2–

38°C – F

43°C – – – – – –

Remarks on application:

Motor

Motor type RSCR/CSIR

LRA (rated after 4 sec. UL984), HST | LST A 4.2 2.1

Cut in Current, HST | LST A 4.2 6.6

Resistance, main | start winding (25°C) Ω 38.0 14.0

Design

Displacement cm

Oil quantity (type) cm

Maximum refrigerant charge g 300

Free gas volume in compressor cm

Weight without electrical equipment kg 4.3

Dimensions

Height mm A 137

Suction connector location/I.D. mm | angle C 6.5 | 41.5°

material | comment Cu-plated steel | Al cap

Process connector location/I.D. mm | angle D 6.5 | 45°

material | comment Cu-plated steel | Al cap

Discharge connector location/I.D. mm | angle E 5.0 | 21°

material | comment Cu-plated steel | Al cap

Oil cooler connector location/I.D. mm | angle F –

material | comment –

Connector tolerance I.D. mm ±0.09, on 5.0 +0.12/+0.20

Remarks:

LBP MBP HBP LBP MBP HBP

2F2

3

3

3

150 (polyolester)

B 135

B1 128

B2 73

– F2–

2.00

850

S = Static cooling normally sufcient
O = Oil cooling
F1 = Fan cooling 1.5 m/s
(compressor compartment temperature
equal to ambient temperature)
F2 = Fan cooling 3.0 m/s necessary
SG = Suction gas cooling normally sufcent
– = not applicable in this area

June 2012 Manufactured by Secop for Danfoss - DEHC.ED.401.K5.02 / 520N1347 1/2

EN 12900 Household (CECOMAF) 220V, 50Hz, fan cooling F

2

Evap. temp. in °C -45 -40 -35 -30 -25 -23.3 -20 -15 -10 -6.7 -5 0 5 7.2 10 15 20

Capacity in W 28.0 31.6 39.3 53.0 69.4 82.0 89.0 112 140 153 172 209

Power cons. in W 48.0 49.6 53.2 59.5 66.6 72.0 74.3 82.2 90.0 93.4 97.5 104

Current cons. in A 0.46 0.47 0.48 0.50 0.52 0.53 0.54 0.57 0.59 0.61 0.63 0.66

COP in W/W 0.58 0.64 0.74 0.89 1.04 1.14 1.20 1.37 1.55 1.64 1.76 2.00

ASHRAE LBP 220V, 50Hz, fan cooling F

2

Evap. temp. in °C -45 -40 -35 -30 -25 -23.3 -20 -15 -10 -6.7 -5 0 5 7.2 10 15 20

Capacity in W 34.5 39.0 48.5 65.4 85.8 102 110 139 173 190 213 260

Power cons. in W 48.0 49.6 53.2 59.5 66.6 72 74.3 82.2 90.0 93.4 97.5 104

Current cons. in A 0.46 0.47 0.48 0.50 0.52 0.53 0.54 0.57 0.59 0.61 0.63 0.66

COP in W/W 0.72 0.79 0.91 1.10 1.29 1.42 1.48 1.69 1.93 2.04 2.19 2.49

EN 12900 Household (CECOMAF) 220V, 60Hz, fan cooling F

2

Evap. temp. in °C -45 -40 -35 -30 -25 -23.3 -20 -15 -10 -6.7 -5 0 5 7.2 10 15 20

Capacity in W 34.0 38.5 47.9 63.8 82.3 96.0 104 129

Power cons. in W 51.5 54.8 61.0 70.2 79.1 88.0 87.8 96.4

Current cons. in A 0.43 0.43 0.44 0.45 0.47 0.48 0.49 0.51

COP in W/W 0.66 0.70 0.78 0.91 1.04 1.13 1.18 1.33

ASHRAE LBP 220V, 60Hz, fan cooling F

2

Evap. temp. in °C -45 -40 -35 -30 -25 -23.3 -20 -15 -10 -6.7 -5 0 5 7.2 10 15 20

Capacity in W 42.0 47.5 59.1 78.8 102 119 128 159

Power cons. in W 51.5 54.8 61.0 70.2 79.1 85.0 87.8 96.4

Current cons. in A 0.43 0.43 0.44 0.45 0.47 0.48 0.49 0.51

COP in W/W 0.82 0.87 0.97 1.12 1.29 1.41 1.46 1.65

Accessories for PL35G Figure Code number Test conditions EN 12900/

ASHRAE

CECOMAF

PTC starting device 6.3 mm spade connectors

4.8 mm spade connectors 103N0018 Ambient temperature 32°C 32°C

a1

103N0011 Condensing temperature 55°C 54.4°C

Starting relay 6.3 mm spade connectors a2 117U6021 Suction gas temperature 32°C 32°C

Start. capacitor 60 µF 6.3 mm spade connectors c 117U5014 Liquid temperature no subcooling 32°C

Cover b 103N0492

Cord relief d 103N1010 Mounting accessories Code number

Protection screen PTC g 103N0476 Bolt joint for one comp. Ø: 16 mm 118-1917

Bolt joint in quantities Ø: 1 6 mm 118-1918

Snap-on in quantities Ø : 16 mm 118-1919

Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to
products already on order provided that such alterations can be made without subsequential changes being necessary in specications already agreed.
All trademarks in this material are property of the respective companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.

2/2 Manufactured by Secop for Danfoss - DEHC.ED.401.K5.02 / 520N1347 June 2012