Danfoss IKORE R11 Installation guide
[1]
[2]
[3]
I
II
RX
I
II
RX
I
II
Installation Guide
Remote Control
IKORE + R11
Danfoss does not take responsibility for incorrect installation or
any frequency interference.
Chance of unintended machine movement on start up.
Ensure the machine is stopped for the entire duration of the
assembly process.
Keep the work area free and wear protective clothing.
To guarantee the specified autonomy or the product, it is
necessary to use AAA LR03 (x3) Alkaline batteries with nominal
capacities between 900 and 1155 mAh. It is highly
recommended to use brands with PLUS type or similar with
nominal capacities close to 1155 mAh. Rechargeable batteries
are not recommended because of their lower nominal capacity.
1. Connect the power supply and the outputs according to
the connection block diagram provided with the system.
The configuration of the radio node can last up to 1 minute.
4. Press the start button.
The status LED will pulse green until the transmitter is
linked with the receiver. The LED will turn into a continuous
green when the receiver confirms the link.
The system is now fully operational.
2. Insert the EEPROM and the batteries.
3. Push and pull out the STOP button.
The status LED will pulse blue until the stand by mode is
reach, then it will turn into a continuous blue.
©
Danfoss | September 2021 AN290872682441en-000201 | 1
Description
1
2
3
4
5
6
1
2
I /I+II /II
* Data sheet
I
II
I /I+II /II
* Data sheet
I
II
I
II
Hoist Selection
During the hoist selection, activating maneuvers is not allowed.
Hoist selection can only be done in working mode.
Hoist button and LEDs
For more information, please consult the relevant User Manual.
IKORE transmitter
1. LED
2. Maneuver button
3. Start button
4. Hoist selection
5. STOP button
6. Removable EEPROM
R11 receiver
Receiver User Manuals & Datasheets
Transmitter User Manuals & Datasheets
https://www.danfoss.com/en/products/dps/electroniccontrols/human-machine-interfaces-hmi/plus1-remotecontrols/
1. Fixing slots (fixed assembly or anti-vibration or anti-
vibration with magnets)
2. M25 cable gland
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products
already on order provided that such alterations can be made without subsequent changes being necessary in specifications already agreed.
All trademarks in this material are property of the respective companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
2 | © Danfoss | September 2021 AN290872682441en-000201
Loading...