Installation Guide
Hot Wire Cutter
1 Introduction
The Hot Wire Cutter is primarily for the use of cutting Danfoss
SpeedUp panels as well as additional EPS or XPS insulation.
Please be careful when working with the tool to prevent accidents such as burning yourself or your surroundings. The blades can reach temperatures of up to 500 °C. Never touch the blade after the switch has been pressed down. Do not lay the unit against any surface after use until the blade has cooled down.
Do not operate the product in unfavourable ambient conditions, such as:
•Moisture or too high air humidity
•Dust and flammable gases, fumes or solvents.
•Strong vibrations.
2 |
Technical Data |
|
|
|
|
|
Ordering |
088X0612 |
|
|
|
|
Type |
FH-TOM |
|
|
|
|
Operating Voltage |
230 V~ 50-60 Hz (110 V~ 50-60 Hz) |
|
|
|
|
Power Consumption |
60 W |
|
|
|
|
Intermittent Operation |
12s ON / 48s OFF |
|
|
|
|
Weight |
1025 g |
|
|
|
|
Cutting Blades |
|
|
|
|
|
U-shaped blade |
for 16 mm grooves |
|
|
|
|
Straight blade, type C-40 |
for boards up to 40 mm |
|
|
|
3 |
Safety Instructions |
|
Observe these safety instructions at all time!
•The unauthorized conversion and/or modification of the product is inadmissible because of safety and approval reasons (CE).
•The connection cable is to be replaced only by the manufacturer or his servicing agent who have a special tool available.
•The structure of the Hot Wire Cutter complies with safety class II. Make sure that the insulation of the housing is neither damaged nor destroyed.
Danfoss Floor Heating Hydronics |
VICTC502 |
04/2015 |
|
|
Loading...