Danfoss FH-ME Installation guide

Instruction

FH-ME manifold

FH-ME

Capacity

kVS

p	p	p
[mwg]	[bar]	[kPa]

	Q [l/h]
t = 5 ˚C	kW
t = 10 ˚C	kW

Danfoss Heating Solutions

VIUDR12P

05/2012

1

	Instruction	FH-ME manifold
		FH-ME
	FH-ME Installation instruction		FH-ME
	1. The manifold integrated with control valve (with red		1.
	plastic protection cap) must be installed as return pipe,
	the manifold integrated shut off valve insert (with round
	red plastic cover) must be installed as flow pipe.
	2. The end piece and pipe connectors connected to		2.
	manifold should be 1” round thread and sealed by
			1
	rubber sealing material at the end, the length of thread
			14mm
	inserted into the manifold should be less than 14mm.
	3. The valves in both flow and return manifold should be		3.
	fully opened during pressure test.

Technical Data
Test pressure	16 bar			16 bar
Max. working pressure	10 bar
				10 bar
Max. differential pressure	0.6 bar
				0.6 bar
Max. flow temperature	90°C
				90°C
Max. ambient temperature,
	60°C
TWA actuator			TWA	60°C
Note: Maximum operating pressure and temperature given by the
tube manufacturer must not be exceeded.

		900 C 20
		200233
		[phone]
		[phone]
		2 A 20
		100027
		[phone]
	Danfoss A/S	[phone]
	Heating Solutions
	Haarupvaenget 11
		358 10
	8600 Silkeborg	300100
	Denmark	[phone]
	Phone:[phone]	[phone]
	Fax: [phone]	http://www.danfoss.com.cn
	Email: [e-mail]
		http://heating.danfoss.com
	www.heating.danfoss.com	http://cn.heating.danfoss.com
	Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed	Danfoss Danfoss
	material. Danfoss reserves the right to alter its products without notice. This also applies to prod-
	ucts already on order provided that such alterations can be made without subsequential changes	Danfoss Danfoss
	being necessary in specifications already agreed.	Danfoss A/S
	All trademarks in this material are property of the respective companies. Danfoss and the Danfoss
	logotype are trademarks of Danfoss A/S. All rights reserved.

013R9560 & VIUDR12P	Produced by Danfoss A/S © 05/2012