Danfoss FC 300 Installation guide

■

FC 300 Remote Mounting Kit for LCPFC 300 Remote Mounting Kit for LCP

FC 300 Remote Mounting Kit for LCP

FC 300 Remote Mounting Kit for LCPFC 300 Remote Mounting Kit for LCP

VLT® AutomationDrive FC 300

Ordering number: 130B1113Ordering number: 130B1113

Ordering number: 130B1113

Ordering number: 130B1113Ordering number: 130B1113
LCP Kit with graphical LCP, fasteners, 3 m cable
and gasket.

Ordering number: 130B1114Ordering number: 130B1114

Ordering number: 130B1114

Ordering number: 130B1114Ordering number: 130B1114
LCP Kit with numerical LCP, fasteners and
gasket.

Ordering number: 130B1117Ordering number: 130B1117

Ordering number: 130B1117

Ordering number: 130B1117Ordering number: 130B1117
LCP Kit without LCP is also available.

MI.33.C3.02 - VLT® is a registered Danfoss trademark

1

Installation and Mounting InstructionsInstallation and Mounting Instructions

Installation and Mounting Instructions

Installation and Mounting InstructionsInstallation and Mounting Instructions

Use the remote build in kit to move the LCP to the front of a cabinet. The enclosure is IP65. Let the
gasket prongs slip under the edge of the LCP as illustrated below. Tighten the fastening screws with a
torque of 0,14-0,16 Nm (or as a rule of thumb, two turns after the screw has made contact).

VLT® AutomationDrive FC 300

130R0050 Rev. 2009-10-12

*MI33C302*