Danfoss ECI 30-2, ECI 50-2 Installation guide [da]
INSTRUCTIONS
ECI 30-2, ECI 50-2
Montering - Mounting - Montage mm (inch)
047C417
Mål
- Dimensions - Abmessungen mm (inch)
ECI 30
ECI 50
047C0417
DK Hvis enhed er monteret vandret reducer strøm med 50%
UK If unit is mounted horizontally derate current by 50%
!
D Falls Einheit horizontal montiert wird, reduziert sich der Strom
um 50%.
Forbindelse - Wiring - Verdrahtung
75°C
Kabel/ wire* mm2 (AWG) mm2 (AWG)
1.5 - 6 0
(16 - 10) (20 - 16)
2 x 1.5 - 6 2 x 0.5 - 0.75
(
2 x 16 - 10) (2 x 20 - 18)
1.5 - 10 0
(16 - 8) (20 - 16)
2 x 1.5 - 6 2 x 0.5 - 1.5
(
2 x 16 - 10) (2 x 20 - 16)
1.5 - 10 0
(16 - 8) (20 - 16)
2 x 1 - 6 2
(2 x 16 - 10) (2 x 20 - 16)
Pozidrive 2
1
.2 Nm max. N.A.
10.6 lb-in max.
6 mm 3
1.2 Nm max. 0.5 Nm max.
10.6 lb-in max. 4.4 lb-in max.
- Vigtigt: (Overhold max. skruedrejningsmomenter)
- Important: (Observe the maximum screw torque limits)
- Wichtig: (Max. Drehmoment beachten)
.5 - 1.5
.5 - 1.5
.5 - 1.5
x 0.5 - 1.5
mm
DK Køleplade skal holdes ren. Luftstrøm må ikke blokeres
UK
!
D Kühlflächen freihalten. Luftstrom muß ungehindert fließen
* Use copper conductor only
Keep heat sink clean. Airflow should not be blocked
A1 - A2, A3 - A4
2
4-230V
037N0013 - N0018
≅
5-24 V
037N0019 - N0024
≡
UL: Use thermal overload protection as required by the National Electric Code
Maximum surrounding temperature 40 °C.
© Danfoss | DCS (rja) | 2015-09
IC.PI.C50.G2.51
520B6899
Loading...