Danfoss ECI 30-1, ECI 50-1, ECI 63-1 Installation guide [da]

0 (0)

INSTRUCTIONS

ECI 30-1, ECI 50-1, ECI 63-1

<![if ! IE]>

<![endif]>047C0416

Montering - Mounting - Montage

mm (inch)

	DK	Hvis enhed er monteret vandret reducer strøm med 50%
!	UK	If unit is mounted horizontally derate current by 50%
!	D	Falls Einheit horizontal montiert wird, reduziert sich der Strom
		um 50%.

Mål - Dimensions - Abmessungen •

mm (inch)

ECI 30

ECI 50

ECI 63

	DK	Køleplade skal holdes ren. Luftstrøm må ikke blokeres
!	UK	Keep heat sink clean. Airflow should not be blocked
!	D	Kühlflächen freihalten. Luftstrom muß ungehindert fließen

Forbindelse - Wiring - Verdrahtung

75°C

Kabel / wire*

mm2 (AWG)

1.5

- 6

0.5 - 1.5

(16 - 10)

(20 - 16)

2 x 1.5 - 6

2 x 0.5 - 0.75

(2 x 16 - 10)

(2 x 20 - 18)

1.5 - 10

0.5 - 1.5

(16 - 8)

(20 - 16)

2 x 1.5 - 6

2 x 0.5 - 1.5

(2 x 16 - 10)

(2 x 20 - 16)

1.5 - 10

0.5 - 1.5

(16 - 8)

(20 - 16)

2 x 1 - 6

2 x 0.5 - 1.5

(2 x 16 - 10)

(2 x 20 - 16)

Pozidrive 2

1.2 Nm max.

N.A.

10.6 lb-in max.

6 mm

3 mm

1.2 Nm max.

0.5 Nm max.

10.6 lb-in max.

4.4 lb-in max.

A1 - A2

24 - 230V	5 - 24V ≡
037N0001 - N0006	037N0007 - N0012
037N0079, 0081, 0083*)	037N0078, 0080, 0082*)
*) Not CSA/ UL approved

-Vigtigt: (Overhold max. skruedrejningsmomenter)

-Important: (Observe the maximum screw torque limits)

-Wichtig: (Max. Drehmoment beachten)

* Use copper conductor only

UL:	Use thermal overload protection as required by the National Electric Code
	Maximum surrounding temperature 40 °C.

<![if ! IE]>

<![endif]>047C0416

© Danfoss \| DCS (rja) \| 2015-09	IC.PI.C50.F3.51
	520B6898