Danfoss ECI 10-3, ECI 20-3 Installation guide [da]

INSTRUCTIONS

ECI 10-3, ECI 20-3

<![if ! IE]>

<![endif]>047C418

Montering - Mounting - Montage	mm (inch)	Mål - Dimensions - Abmessungen	mm (inch)
		ECI 10

ECI 20

	DK	Hvis enhed er monteret vandret reducer strøm med 50%	!		DK					Køleplade skal holdes ren. Luftstrøm må ikke blokeres
!	UK	If unit is mounted horizontally derate current by 50%			UK					Keep heat sink clean. Airflow should not be blocked
	D	Falls Einheit horizontal montiert wird, reduziert sich der Strom		D						Kühlflächen freihalten. Luftstrom muß ungehindert fließen
		um 50%.
Forbindelse - Wiring - Verdrahtung										A1 - A2

75°C
Kabel/ wire*					mm2 (AWG)	mm2 (AWG)
				0.75 - 4		0.5 - 1.5
				(18 - 12)		(20 - 16)
					2 x 1	2 x 0.5 - 0.75
					(2 x 18)	(2 x 20 - 18)
				0.75 - 6		0.5 - 1.5
				(18 - 10)		(20 - 16)
					2 x 0.75 - 2.5	2 x 0.5 - 1.5
					(2 x 18 - 14)	(2 x 20 - 16)
				0.75 - 6		0.5 - 1.5
				(18 - 10)		(20 - 16)
					2 x 0.75 - 1.5	2 x 0.5 - 1.5
					(2 x 18 - 16)	(2 x 20 - 16)
					Pozidrive 1
					0.5 Nm max.	N.A.
					4.4 lb-in max.
					4 mm	3 mm
					0.5 Nm max.	0.5 Nm max.
					4.4 lb-in max.	4.4 lb-in max.

24-230 V	5-24 V ≡
037N0025 - N0030	037N0031 - N 0036

(+)

- Vigtigt: (Overhold max. skruedrejningsmomenter)

-Important: (Observe the maximum screw torque limits)

-Wichtig: (Max. Drehmoment beachten)

* Use copper conductor only

UL: Use thermal overload protection as required by the National Electric Code Maximum sourrounding temperature 40 °C.

<![if ! IE]>

<![endif]>047C0418

© Danfoss | DCS (rja) | 2015-09	IC.PI.C50.H2.51
	520B6900