Danfoss ECI 10-1, ECI 15-1 Installation guide [da]

			INSTRUCTIONS
	<![if ! IE]> <![endif]>047C0425		ECI 10-1/ ECI 15-1
		Montering - Mounting - Montage	mm (inch) Mål - Dimensions - Abmessungen mm (inch)
			ECI 10/ ECI 15

	!	DK	Hvis enhed er monteret vandret reducer strøm med 50%			!	DK	Køleplade skal holdes ren. Luftstrøm må ikke blokeres
		UK	If unit is mounted horizontally derate current by 50%				UK	Keep heat sink clean. Airflow should not be blocked
		D Falls Einheit horizontal montiert wird, reduziert sich der					D	Kühlflächen freihalten. Luftstrom muß ungehindert fließen
			Strom um 50%.
	Forbindelse - Wiring - Vedrahtung							A1 - A2
		75°C						24-230V	5-24 V ≡
		Kabel/ wire*		mm2 (AWG)	mm2 (AWG)			037N0064	037N0063
								037N0066	037N0065
				0.75 - 4	0.5 - 1.5			037N0068	037N0067
				(18 - 12)	(20 - 16)				037N0072*)
				2 x 1	2 x 0.5 - 0.75			*) Not UL approved
				(2 x 18)	(2 x 20 - 18)
				0.75 - 6	0.5 - 1.5
				(18 - 10)	(20 - 16)
				2 x 0.75 - 1.5	2 x 0.5 - 1.5
				(2 x 18 - 14)	(2 x 20 - 16)
				0.75 - 6	0.5 - 1.5
				(18 - 10)	(20 - 16)
				2 x 0.75 - 1.5	2 x 0.5 - 1.5
				(2 x 18 - 16)	(2 x 20 - 16)
				Pozidrive 1
				0.5 Nm max.	N.A.
				4.4 lb-in max.
				4 mm	3 mm
				0.5 Nm max.	0.5 Nm max.
				4.4 lb-in max.	4.4 lb-in max.
						-	Vigtigt:	(Overhold max. skruedrejningsmomenter)
	* Use copper conductor only					-	Important: (Observe the maximum screw torque limits)
						- Wichtig:		(Max. Drehmoment beachten)
	UL:	Use thermal overload protection as required by the National Electric Code
		Maximum surrounding temperature 40°C

<![if ! IE]>

<![endif]>047C0425

© Danfoss | DCS (rja) | 2015-09	IC.PI.C50.I2.51
	520B6897