Installation guide
ELIMINATOR® Hermetic filter drier
Type DMSC
<![if ! IE]> <![endif]>023R9523 |
(CO2 for sub-critical application) |
|
PS/MWP: 52 bar / 754 psig |
||
|
Refrigerant R744 (CO2 ) |
|
Media Temperature range: -30 °C – 17 °C / -22 °F – 63 °F |
||
|
|
|
|
|
|
|
Pure copper: |
Keep flames away |
|
Customer best practices will still be |
|
|
Size: 1/4, 3/8, 1/2, |
from body |
|
needed: |
|
|
6 mm, 8 mm, 12 mm |
|
|
• Use wet wrap when installing. |
|
|
Steel: |
|
|
• |
Braze the joints |
|
|
|
• Let them cool down |
||
|
Size: 1/4, 3/8, 1/2 |
|
|
• Clean the welding area after the |
|
|
|
|
|
|
installation (remove remaining flux |
|
|
|
|
|
with a brush) |
|
|
|
|
• |
This is an important operation and |
|
|
|
|
|
needs to be done with great care to |
|
|
|
|
|
remove all remaining flux. |
|
|
|
|
• Paint/Anti-corrosive needs to cover all |
|
|
|
|
|
|
open steel parts, areas where the black |
|
|
|
|
|
original paint has been burnt due to |
|
|
|
<![if ! IE]> <![endif]>Danfoss 23Z7016.10 |
|
brazing and at least 3 cm approx of the |
|
|
|
|
copper tube |
|
|
|
|
|
|
|
|
|
|
|
• Paint the joints twice |
|
|
Flare steel connectors |
Applies compatible oil on the steel connector (threads) |
|||
|
|
||||
|
<![if ! IE]> <![endif]>Dan 9G8 |
|
|
|
|
|
Pure copper extended connectors |
|
|
|
|
|
|
When applying the torque wrench to the filter drier fix it so there is no movement. |
|||
|
|
Also avoid movement in the tubing when installing. |
<![endif]>023R9523
© Danfoss | Climate Solutions (nb) | 2021.06 |
AN263430815816en-000201 | 1 |