Danfoss DEVIreg 130, DEVIreg 132 Data sheet
Data Sheet
DEVIreg™ 130,
DEVIreg™ 132
DEVIreg™ 130/132 is a line of simple electronic 16 Amps thermostats with possibility to
be installed directly on the wall. The thermostats have only one button for adjusting the
temperature and for OFF mode. Furthermore, it has an LED indicator showing standby
(green light) and heating (red light) periods. The thermostats do not have wire sensor failure
monitoring. Wire temperature sensor included in the set.
DEVIreg™ 130 is equipped with a wire (floor) sensor used for control of Comfort Floor
Heating applications. The thermostat has a dial for adjusting the temperature setting with a
numeric scale from , to 5 (meaning from OFF, 5 °C to 45 °C and each step corresponds
to approx. 9 °C). This type of thermostat can be used for outdoor applications too – Ice and
Snow Melting on Ground, Frost Protection on Roofs, Pipe Tracing, etc., because it doesn’t
have wire sensor failure monitoring.
DEVIreg™ 132 is equipped with a built-in air sensor to control the room temperature and an
additional floor (wire) sensor to limit the maximum floor temperature. The main application
is Total (Direct) Heating via Floor systems. The thermostat has a dial for adjusting the room
temperature, with a degree scale from , to 35°C (which means from OFF, 5°C to 35°C).
Adjusting maximum floor temperature is provided with potentiometer placed under front
cover (default 35°C).
Benefits:
• Low standby consumption
• Installation on the wall
• LED indication
• Frost protection
• Ice and snow melting applications
Standard compliance:
• EN/IEC 60730-1 (general)
• EN/IEC 60730-2-9 (thermostat)
Approvals:
Type
Operation voltage
Standby power consumption
Resistive load
Inductive load
Hysteresis
Ambient temperature
Frost protection
Cable specification max
Ball pressure test temperature
Pollution degree
Controller type
Storage temperature
IP class
Protection class
Dimensions (H/W/D)
Weight
Value
220 - 240 V, 50/60 Hz
Max. 5 W
Max 16 A (3680 W) @ 230 V
Max. 1 A, cos φ = 0,3
± 0,2°C
-10 °C to +30 °C
5 °C -
1 x 4 mm2 or 2 x 2,5 mm
75°C
2 (domestic use)
1 C
-20 °C to +65 °C
IP 30
Class II -
82 x 82 x 36 mm
90 g
2
Types
Item no. Product name Temp. range Sensor type Marking EAN no.
140F1010 DEVIreg™ 130 5-45 °C
140F1011 DEVIreg™ 132
max. floor temp.: 20-50 °C (default 35 °C)
Room: 5-35 °C,
Wire sensor, 3 m,
NTC 15 kOhm at 25 °C
Built-in room sensor and
wire sensor, 3 m,
NTC 15 kOhm at 25 °C
D130 5703466208953
D132 5703466208960
Produced by Danfoss ©AI032686451000en-000103
Connection schemes
1234
DEVIreg™ 130 DEVIreg™ 132
...5
(5...45 °C)
NTC
Room t°
sensor
1234
t°
Max. floor t°
NTC
Load
max. 16 A
LN
L
N
PE
230 V~
LN
t°
Load
max. 16 A
L
230 V~
t°
N
PE
Produced by Danfoss ©AI032686451000en-000103
Loading...