Instructions
Cutting in EvoFlat front cover
for extra heating circuit.
Fig 1
Inside of EvoFlat front cover.
Fig 2
Inside of EvoFlat front cover, with close up of area,
where opening for extra heating circuit must
be cut out.
Danfoss District Energy VM.JV.B1.02 DKDHR
1
Instructions
Fig. 3
The white lines shown on g. 3 mark the limit as to
how much can be removed of the cover.
Fig 4
The ruler shown on g. 4 marks the limit as to what
is recommended to remove of the outer wall of the
cover.
Fig 5
Use a sharp knife to cut through the EPP. Here a craft
knife is used.
2
DKDHR VM.JV.B1.02 Danfoss District Energy
Instructions
Fig. 6
It is recommended rst to remove the section to be
cut away from outer wall of the cover, to be able to
make the nal cutaways inside the cover, as shown on
g. 8.
Fig 7
Cut according to the white line.
Fig 8
Make a cut, as shown on g. 8 and remove the cut-out
section of the outer wall.
Danfoss District Energy VM.JV.B1.02 DKDHR
33
Instructions
Fig. 9
Make cuts in the inner wall of the cover according to
the white lines, as shown on g. 9.
Fig 10
The inner wall has to be cut down into the same
height as the outer wall.
Fig 11
The job is nished.
Please note: The more material is removed the weaker
the cover becomes. - Therefore remove only as much
of the cover as necessary. - This is dependent on the
piping for the extra heating circuit.
Fig. 7
VM.JV.B1.02
Produced by Danfoss Redan A/S © 05/2015
Loading...