BD220CL
Direct Current Compressor
R404A/R507
12V DC - with 101N08xx Series Controllers
General
Code number (without electronic units) 102Z3020
Compressor module 101N0800, 30 pcs: 101N0801
Application module 101N0820, 24 pcs: 101N0821
Alternative (one interface only):
Electronic Unit (no fan connection/no twin option)
Approvals –
Compressors on pallet 125
Application
Application LBP
Evaporating temperature °C -45 to -5
Voltage range VDC 9.6 - 17
Max. condensing temperature continuous (short)
Max. winding temperature continuous (short) °C 125 (135)
Cooling requirements
Application LBP MBP HBP
32°C F
38°C F
43°C F
Remarks on application:
- evaporator fan max. 200W
- condenser fan max. 100W
101N0830, 30 pcs: 101N0831
°C 50 (60)
1
1
1
– –
– –
– –
S = Static cooling normally sufcient
O = Oil cooling
F
= Fan cooling 1.5 m/s
1
(compressor compartment temperature
equal to ambient temperature)
F2 = Fan cooling 3.0 m/s necessary
SG = Suction gas cooling normally sufcent
– = not applicable in this area
Motor
Motor type variable speed
Resistance, all 3 windings (25°C) Ω 0.1
Design
Displacement cm
Oil quantity (type) cm
Maximum refrigerant charge g 400
Free gas volume in compressor cm
Weight - Compressor/Electronic unit kg 7.9 / 0.33 / 0.28 (101N820)
Battery protection settings
Voltage Min. value Default Max. value
Cut out (0.1 steps) VDC 9.6 10.4 17
Cut in diff. (0.1 steps) VDC 0.5 1.3 10
Dimensions
Height mm A 173
Suction connector location/I.D. mm | angle C 6.2 | 90°
material | comment Cu-plated steel | Al cap
Process connector location/I.D. mm | angle D 6.2 | 31.5°
material | comment Cu-plated steel | Al cap
Discharge connector location/I.D. mm | angle E 5.0 | 28°
material | comment Cu-plated steel | Al cap
Connector tolerance I.D. mm ±0.09, on 5.0 +0.12/+0.20
3
3
3
280 (polyolester)
B 169
B1 –
B2 –
3.86
1690
July 2013 Manufactured by Secop for Danfoss - DEHC.ED.100.X2.02 / 520N1484 1/2
Capacity (EN 12900 Household/CECOMAF) 12V DC, fan cooling F1watt
rpm \ °C -45 -40 -35 -30 -25 -23.3 -20 -15 -10 -6.7 -5 0
2,500 26,4 47,1 71,9 101 136 149 177 224 278 318 340
3,000 31,4 56,0 85,5 121 162 178 210 266 331 379 405
3,500 36,3 64,9 99,2 140 188 206 244 309 384 439 470
4,000 40,8 73,1 112 158 212 232 275 349 433 495 530
Capacity (ASHRAE LBP) 12V DC, fan cooling F
rpm \ °C -45 -40 -35 -30 -25 -23.3 -20 -15 -10 -6.7 -5 0
watt
1
2,500 31 55 83 117 158 173 205 260 323 370 396
3,000 36 65 99 140 188 206 244 310 385 441 472
3,500 42 75 115 162 218 239 284 360 447 512 547
4,000 47 85 130 183 246 270 320 405 504 577 617
Power consumption 12V DC, fan cooling F
rpm \ °C -45 -40 -35 -30 -25 -23.3 -20 -15 -10 -6.7 -5 0
watt
1
2,500 65.2 82.8 98.9 114 129 133 143 158 174 185 191
3,000 75.2 96.0 115 134 152 158 170 190 210 225 233
3,500 84.3 108 131 152 174 181 196 219 245 263 272
4,000 94.3 121 147 172 197 206 223 251 281 303 314
Current consumption 12V DC, fan cooling F
rpm \ °C -45 -40 -35 -30 -25 -23.3 -20 -15 -10 -6.7 -5 0
1
2,500 5.43 6.90 8.24 9.50 10.71 11.12 11.92 13.16 14.48 15.40 15.90
3,000 6.27 8.00 9.62 11.16 12.67 13.19 14.20 15.81 17.53 18.75 19.42
3,500 7.03 9.02 10.89 12.69 14.48 15.10 16.32 18.27 20.38 21.89 22.71
4,000 7.86 10.12 12.26 14.34 16.43 17.15 18.59 20.90 23.41 25.22 26.20
COP (EN 12900 Household/CECOMAF) 12V DC, fan cooling F
rpm \ °C -45 -40 -35 -30 -25 -23.3 -20 -15 -10 -6.7 -5 0
W/W
1
2,500 0.41 0.57 0.73 0.89 1.06 1.12 1.23 1.42 1.60 1.72 1.78
3,000 0.42 0.58 0.74 0.90 1.07 1.12 1.23 1.40 1.57 1.68 1.74
3,500 0.43 0.60 0.76 0.92 1.08 1.14 1.25 1.41 1.57 1.67 1.72
4,000 0.43 0.60 0.76 0.92 1.08 1.13 1.23 1.39 1.54 1.64 1.68
COP (ASHRAE LBP) 12V DC, fan cooling F
rpm \ °C -45 -40 -35 -30 -25 -23.3 -20 -15 -10 -6.7 -5 0
W/W
1
2,500 0.47 0.66 0.84 1.03 1.23 1.30 1.43 1.65 1.86 2.00 2.07
3,000 0.48 0.68 0.86 1.05 1.24 1.30 1.43 1.63 1.83 1.96 2.02
3,500 0.50 0.69 0.88 1.07 1.26 1.32 1.45 1.64 1.83 1.95 2.01
4,000 0.50 0.70 0.88 1.06 1.25 1.31 1.43 1.62 1.79 1.91 1.96
Test conditions EN 12900/CECOMAF ASHRAE LBP
Condensing temperature
45°C 45°C
Ambient temperature 32°C 32°C
Suction gas temperature 32°C 32°C
Liquid temperature no subcooling 32°C
Operational errors
Error
code
6
5
4
3
2
1
A
Can be read out in the software TOOL4COOL®
Thermostat failure
(If the NTC thermistor is short-circuit or has no connection,
the electronic unit will enter manual mode).
Thermal cut-out of electronic unit
(If the refrigeration system has been too hea vi ly loaded,
or if the ambient tem pe ra ture is high, the electronic unit
will run too hot).
Minimum motor speed error
(If the refrigeration system is too heavily loaded, the
motor cannot maintain minimum speed at approximately
1,850 rpm).
Motor start error
(The rotor is blocked or the differential pressure in the
refrigeration system is too high).
Fan over-current cut-out
(The fan loads the electronic unit with too high current).
Battery protection cut-out
(The voltage is outside the cut-out setting).
Error type
Accessories for BD220CL
Mounting Code number
Bolt joint for one compressor Ø: 16 m m 118-1917
Bolt joint in quantities Ø: 16 mm 118-1918
Snap-on in quantities Ø: 1 6 mm 118-1919
Electrical
(cables, sensors, etc.)
One Wire/LIN gateway 105N9501 –
communication cable 105N9524 –
Bluetooth® gateway 105N9502 –
communication cable 105N9525 –
Temperature sensor 470 mm 105N9612 105N9613, 200 pcs.
Temperature sensor 1000 mm 105N9614 105N9615, 100 pcs.
Temperature sensor 1500 mm 105N9616 105N9617, 100 pcs.
Comm. cable, 1500 mm – 105N9553, 80 pcs.
Comm. cable, 3000 mm – 105N9554, 45 pcs.
Display cable, 1500 mm – 105N9557, 65 pcs.
Display cable, 3000 mm – 105N9558, 35 pcs.
Not deliverable from Secop
Slow-blow fuse compressor module 60A
Slow-blow fuse application module 30A
Main switch
Code number
Single pack I - Pack
rated to min. 100A
Legend, see Intructions for details.
A) Application module 101N0820
B) Compressor module 101N0800, 12 V DC
C) Supply cables
Compressor communication cable assembly
D)
E) Electronic unit 101N0830 (alternative)
1) Mounting screws
2) Battery
3) Fuse
4) Main switch
5) Evaporator fan
6) Condenser fan
7) Mechanical thermostat
8) NTC temperature sensor
9) NTC auxiliary temperature sensor
10) Compressor(s)
11) One Wire/LIN gateway comm. interface
12) Modbus-compatible device
13) Bluetooth® gateway comm. interface
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to
products already on order provided that such alterations can be made without subsequential changes being necessary in specications already agreed.
All trademarks in this material are property of the respective companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
2/2 Manufactured by Secop for Danfoss - DEHC.ED.100.X2.02 / 520N1484 July 2013