Danfoss AK-UI55 Installation guide

Installation Guide

NEMA4

AK-UI55 Bluetooth

084R8057

AN324530821966e n -000104

Identiﬁcation

Mounting

Connection

= 0 – 55 °C

amb

32 – 130 °F Non condensing

Dimensions

IP65

0.5 - 3.0 mm

RJ 12

L max. = 100 m

AK-UI cable, 3 m: 084B4078 AK-UI cable, 6 m: 084B4079

AK-UI55 Bluetooth

Access to parameters via Bluetooth and app

1. App can be downloaded from App Store and Google Play Name = AK-CC55 Connect Start the app.

App Store Google Play

2. Click on the display’s Bluetooth button for 3 seconds. The Bluetooth light will then ﬂash while display is showing the controller’s address.

3. Connect to the controller from the app.

L1 + L2 : max. = 100 m

Without conﬁguration, the display can show the same information as the AK-UI55 Info version.

Loc The operation is locked and cannot be operated via Bluetooth.

Unlock from the system device.

AN324530821966en-000104 | 1

Statements for the AK-UI55 Bluetooth display:

FCC COMPLIANCE STATEMENT

CAUTION: Changes or modiﬁcations not expressly approved could void your authority to use this equipment This device complies with Part 15 of the FCC Rules. Operation to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation

INDUSTRY CANADA STATEMENT

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

NOTICE FCC COMPLIANT NOTICE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment oﬀ and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit diﬀerent from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Modiﬁcations: Any modiﬁcations made to this device that are not approved by Danfoss may void the authority granted to the user by the FCC to operate this equipment.

Danfoss Cooling 11655 Crossroads Circle Baltimore, Maryland 21220 United States of America www.danfoss.com

EU CONFORMITY NOTICE

Hereby, Danfoss A/S declares that the radio equipment type AK-UI55 Bluetooth is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.danfoss.com

Danfoss A/S Nordborgvej 81 6430 Nordborg Denmark www.danfoss.com

China Commitment

Type Approval for Radio Transmitting Equipment CMIIT ID: 2020DJ7408

2 | AN324530821966en-000104