Dakota LAT-NR421 User Manual

INSTALLATION INSTRUCTIONS

LAT-NR421

LED Tail Lights for 1973 Impala, 1979 Caprice,

MAN#650249

1980-1985 Impala

Kit Includes:

Installation:

1. Remove the original bulb connector from the back side of the housing.

2. Remove the tail light housing from the car.

3. Remove any body trim from the housing so the screws holding the lens on are exposed.

4. Remove the tail light lens.

5. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.

6. Remove the lock nuts and aluminum back plate from the back of the new LED assembly.

MAN#650249

7. Insert the new LED assembly through the hole where the original bulb and connector were.
Use caution when feeding the wires through to avoid damaging the wire insulation.

8. Feed the wires through the large hole in the back plate and attach the back plate onto the back
side of the housing. The flat side of the mounting disk should be toward the outside and the
side with the slight raised center should go in toward the housing. This will align the mount in
the original housing.

9. Secure the back plate with the supplied #6 lock nuts.

10. Make sure the original lens gasket is in place and replace the tail light lens.

11. Replace the body trim and reinstall the tail light housing into the vehicle.

MAN#650249