Dakota LAT-NR230 User Manual

MAN#650188 rev. B

Kit Includes:

Installation:

1. Remove the two screws and tail light lens.

INSTALLATION INSTRUCTIONS

LAT-NR230

LED Tail Lights for 1960-1972 Chevy Fleetside Pickup
and 1955-58 Chevy Cameo

2. Remove the light bulb.

3. Push and twist to remove the plastic wire socket from the back side of the housing.

4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.

5. Remove the nut and round metal spacer from the back of the new LED assembly.

MAN#650188 rev. B

6. Insert the new LED assembly through the hole where the original bulb and connector

were. Use caution when feeding the wires through to avoid damaging the wire
insulation.

7. Feed the wires through the round metal spacer, with one wire going through each outer

hole in the aluminum spacer. The larger diameter ring should be away from the tail
light housing. Use caution when feeding the wires through to avoid damaging the wire
insulation.

8. Secure the metal spacer with the supplied #6 nut.

9. Place the original lens gasket into place and replace the tail light lens. Tighten the

screws down carefully.

10. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the

wires from LED assembly to appropriate length once mounted, making sure wires are
routed cleanly and securely.

11. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new

LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle
harness and mating LED assembly wire into a connector and crimp following
instructions below.

*For the best connection, soldering is recommended. But to simplify installation, the supplied connectors will

provide a fast weather resistant connection.

MAN#650188 rev. B