Dakota LAT-NR162 User Manual

INSTALLATION INSTRUCTIONS

LAT-NR162

LED Tail Lights for ’66 Impala/Caprice and ’67 Caprice

MAN#650160

Kit Includes:

Installation:

’66 Impala ’66 Caprice ’67 Caprice

1. Remove the original bulb connector from the back side of the housing.

2. Remove the light bulb.

3. Remove the tail light housing from the car. There are nuts inside the trunk on the back side of
the housing.

4. Remove the chrome trim plate and tail light lens. These screws are on the back side of the
housing.

5. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.

MAN#650160

6. Remove the screw and aluminum back plate from the new LED assembly. The center hole in
the ’67 Caprice is smaller and offset so there is a special back plate supplied for this
application.

LED assembly Standard back plate ’67 Caprice center hole back plate.

7. Insert the new LED assembly through the hole where the original bulb and connector were
located. Use caution when feeding the wires through to avoid damaging the wire insulation.

8. Feed the wires through the larg e hole on the back plate before attaching it onto the back side
of the hou sing. Flat side of back plate will be on the outside of the tail light housing with the
raised side facing the LED assembly. Make sure to use the special back plate for the small
center hole in the 67 Caprice and align it so the wires come out the top side.

9. Secure the back plate with the supplied #6 screw and lock washer.

MAN#650160