Daewoo YD-092 User Manual

OFF

TEMPERATURE CONTROL

5 inches

NAMES OF THE PARTS

HOW TO OPERATE HOW TO CLEAN

1. EVAPORATOR : The heart of the refrigerator. It evaporates the refrigerant fluid and thereby absorbs heat from the surrounding. Made of pure aluminum.

2. DRAIN PAN : Discards the water that drips of the evaporator when defrosting.

3. CONTROL BOX Regulates the operation of the motor and controls the inside temperature of the refrigerator.

4. PLASTIC COATED SHELF Has full width and can slide out.

5. MAGNETIC DOOR SEALS Keeps the refrigerator virtually airtight all

along the edge, but is nevertheless easy to open.

6. ICE CUBE TRAY : Ice cubes are easy to remove from the tray.

7. BOTTLE RACK for bottles, cans or jars.

8. USABLE RACK for cans or jars.

Starting your new Refrigerator

1. Clean the refrigerator thoroughly. Wipe the outside with a soft dry cloth, the inside with a damp cloth.

2. Keep the door open and insert the power supply cord into the socket.

3. Turn the thermostat dial to “7”. Close the door and let the refrigerator operate for 15-20 minutes. The freezer should then show some traces of frost.

Temperature control

You can control the inside temperature by turning the thermostat dial. Higher numbers mean greater cooling power, smaller numbers mean less cooling power. To make ice cubes in the freezer compartment, set the dial to “7”. The dial does not have to be set exactly on the numbers, but can be any place in between.

NOTE : Wait 3 to 5 minutes before restarting if you unplug the machine.

Unit may fail to operate properly if restarted too quickly.

How to defrost

Defrost the refrigerator when the frost accumulated on the evaporator is about 5mm(1/5inch) thick. Set the thermostat dial to “OFF”. Remove foods. Keep drip tray in place. Defrosting usually takes a few hours. To defrost quickly remove all foods from the refrigerator and leave door open. Never use a knife or other metal instrument to remove ice/frost from the evaporator. After defrosting empty water from drip tray, return the thermostat dial to the desired position to start refrigerating again.

Cleaners: The cleaners noted below are available. Never use harsh, abrasive cleaners, heavy-duty cleaners, or solvents on any surface.

Exterior: Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains and for periodic waxing, use silicon wax.

Evaporator: When refrigerator needs defrosting turn thermostat dial to “OFF”. Do not use sharp instruments.

Refrigeration Section: Wash shelves and other removable parts in warm sudsy water, rinse and dry. Wash interior with baking soda solution (3 table spoons to one quart of water) or warm sudsy water, rinse and dry.

Magnetic Door Seals: Wash with warm sudsy water. The Finishing Touch: Replace all parts and return thermostat dial to desired

setting.

HOW TO INSTALL

▶ Install refrigerator in a convenient location away from extreme heat and

cold. Allow sufficient clearance between the refrigerator and side wall so the door will open for a fully usable interior. Refrigerator is not designed for recessed installation.

▶ Select a place with strong level floor. ▶ Allow 5 inches of space between the

refrigerator’s side and the wall.

WHAT TO DO...

1. When out of operating for a long time:

•Remove the power supply cord.

•Dry your refrigerator opening the door for 2-3 days.

2. When you get ready to move:

•Securely fasten removable interior parts (or move and package them separately)

•Do not lay your refrigerator horizontally, or compressor may be damaged.

When you need service: Before you call for service make sure you need it, check a few things noted below for yourself first.

If refrigerator is not operating:

•Is the power supply cord unplugged?

•Is home fuse blown or circuit breaker off?

If refrigerator is warmer than usual:

•Has the door been open frequently or for a long period?

•Is refrigerator overcrowded-preventing good air circulation?

•Is the hot thing stored without cooling?

•Is the clearance between refrigerator’s side and the wall allowed

sufficiently?

REFRIGERATOR

INSTRUCTION MANUAL

Model No.

YD-092

If there are unusual sounds:

•Is refrigerator placed on the level?

•Are foreign objects behind the refrigerator?

•Are dishes on refrigerator shelves vibrating?

If so, rearrange the dishes.

If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a simmilary qualified person in order to avoid a hazard.

CFC-FREE

󱇲Before use, please read this manual carefully. 󱇲Always remove the drain pan while this refrigerator is running. 󱇲Removing the drain pan will enhance the cooling power and save your

electric cost.