Daewoo VG-101C, VG-165C User Manual

1
6 2 4 3 9587
1
7 2 4 3 5689
4
101121 7 3 5
89 6
1. EVAPORATOR
The heart of the refrigerator. It evaporates the refrigerant fluid and thereby absorbs heat from the surrounding. Made of pure aluminum.
2. DRAIN PAN : (Use of Defrost Only)
Discards the water that drips of the evaporator when defrosting.
3. CONTROL BOX
Regulates the operation of the motor and controls the inside temperature of the refrigerator.
4. SHELF : Has full width and can slide out.
5. RACK for butter, eggs, and small size goods.
6. MAGNETIC DOOR SEALS
Keeps the refrigerator virtually airtight all along the edge, but is nevertheless easy to open.
7. ICE CUBE TRAY Ice cubes are easy to remove from the tray.
8. USABLE RACK for cans or jars.
9. BOTTLE RACK for bottles, cans or jars.
10. CRISPER for vegetables and fruits.
11. SLIDE OUT CRISPER COVER.
NAMES OF THE PARTS
VG-101C VG-165C
2
Cleaners: The cleaners noted below are available. Never use harsh, abrasive cleaners, heavy­duty cleaners, or solvents on any surface.
Exterior: Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains and for periodic waxing, use silicon wax.
Evaporator: When refrigerator needs defrosting turn thermostat dial to “OFF”. Do not use sharp instruments.
Refrigeration Section: Wash shelves and other removable parts in warm sudsy water, rinse and dry. Wash interior with baking soda solution (3 table spoons to one quart of water) or warm sudsy water, rinse and dry.
Magnetic Door Seals: Wash with warm sudsy water.
The Finishing Touch: Replace all parts and return thermostat dial to desired setting.
Install refrigerator in a convenient location away from extreme heat and cold. Allow
sufficient clearance between the refrigerator and side wall so the door will open for a fully usable interior. Refrigerator is not designed for recessed installation.
Select a place with strong level floor.Allow 5 inches of space between the
refrigerator’s side and the wall.
HOW TO CLEAN
HOW TO INSTALL
5 inches
2
HOW TO OPERATE
1. Clean the refrigerator thoroughly. Wipe the outside with a soft dry cloth, the inside with a damp cloth.
2. Keep the door open and insert the power supply cord into the socket.
3. Turn the thermostat dial to “7”. Close the door and let the refrigerator operate for 15-20 minutes. The freezer should then show some traces of frost.
You can control the inside temperature by turning the thermostat dial. Higher numbers mean greater cooling power, smaller numbers mean less cooling power. To make ice cubes in the freezer compartment, set the dial to “7”. The dial does not have to be set exactly on the numbers, but can be any place in between.
Defrost the refrigerator when the frost accumulated on the evaporator is about 5mm(1/5inch) thick. Set the thermostat dial to “OFF”. Remove foods. Keep drip tray in place. Defrosting usually takes a few hours. To defrost quickly remove all foods from the refrigerator and leave door open. Never use a knife or other metal instrument to remove ice/frost from the evaporator. After defrosting empty water from drip tray, return the thermostat dial to the desired position to start refrigerating again.
6
7
5
4
3
2
1
OFF
C
O
L
D
E
R
TEMPERATURE CONTROL
NOTE : Wait 3 to 5 minutes before restarting if you unplug the machine. Unit may
fail to operate properly if restarted too quickly.
Temperature control
Starting your new Refrigerator
How to defrost
Loading...
+ 2 hidden pages