21
1
FEA TURE CHART
! ICE TRAY
@ F SHELF (MOVABLE)
# FREEZER TEMPERATURE
CONTROL KNOB
$ ICE BOX
% CHILLED CASE
^ LAMP COVER
& REFRIGERATOR
TEMPERATURE
CONTROL SWITCH
* R SHELF (MOVABLE)
( VEGETABLE CASE COVER
) VEGETABLE CASE
1 FREEZER POCKET
2 UTILITY POCKET
3 EGG CASE
4 BOTTLE POCKET (LARGE)
5 BOTTLE POCKET (SMALL)
1
3
4
5
2
!
@
#
$
%
^
&
*
(
)
FEA TURE CHART (Only twist)
! F SHELF (MOVABLE)
@ ICE HOLDER ASSEMBY
# ICE CASE FRAME ASSEMBLY
$ ICE BOX
% FREEZER TEMPERATURE
CONTROL KNOB
^ CHILLED CASE
& LAMP COVER
* REFRIGERATOR TEMPERATURE
CONTROL SWITCH
( R SHELF (MOVABLE)
) VEGETABLE CASE COVER
1 VEGETABLE CASE
2 FREEZER POCKET
3 UTILITY POCKET
4 EGG CASE
5 BOTTLE POCKET (LARGE)
6 BOTTLE POCKET (SMALL)
2
4
5
6
3
!
@
#
$
^
&
*
(
)
1
%
■ Ice Case Frame Assembly
1) Fill the ice case with water upto the water level line and insert it into the designated
space in the ice holder.
2) After the water is completely frozen, twist
the ice case handle clockwise and let the
ice fall into the ice box below. When all
ice has been cleared from the ice case,
let go of the handle which will return to its
original position by a return spring
installed.
RETURN SPRING
ICE CASE FRAME
STARTING POINT OF TWISTING
120
°
ICE CASE
4
Temperature is controlled by thermostat automatically. The Temperature Control inside the
refrigerator controls the degree of cooling for each compartment.
The control has four settings from MIN to
WINTER. The WINTER mode is available only if
atmosphere temperature is below 10°C
The control has the four settings from MIN to
WINTER. The WINTER mode is available only if
atmosphere temperature is below 10°C
1. TEMPERATURE CONTROL
T o turn off the refrigerator
NOTE:During spells of hot, humid weather and in rainy season, moisture
may develop on the cabinet, just as water condenses around a cold
glass of water. It is not an abnormal condition; wipe off the moisture
with a dry cloth. This can also happen when the refrigerator is not
installed in an appropriate place.
1. Clean the refrigerator thoroughly. Wipe the outside with a dry cloth, and the inside with
a damp cloth.
2. Set the temperature control knob at normal position.
3. Connect the power supply cord.
Disconnect the power supply cord. Remove icing case and food. Leave doors ajar for
ventilation and dehumidification of both compartments.
Freezer Temperature Control
Refrigerator Temperature Control
MIN MED MAX WINTER
WINTER
MAX
MED
MIN
With the Refrigerating System in operation, it is likely that the cabinet will feel warm at the front
edges and sides. This does not indicate trouble.
It is due to the hot-line used in this type of Refrigerating System which consists of piping hot gas
from the (motor-driven) compressor along the front edges, the sides of the cabinet and the center
partition to prevent dewing. This has nothing to do with the storage temperature inside.
(The thick line indicates the hot-line)
2. RADIANT HEAT
HOW TO OPERA TE
TEMP. CONTROL
TEMP. CONTROL
Starting your new refrigerator
3
CAUTION: 1. Check your voltage before inserting the power supply cord into the socket.
2. Contact the earthing conductor to this unit with an attachment earthing screw.
3. Do not spill liquid on this unit.
4. Do not use flammable spray, such as painting, near this unit.
5. Do not place ignitable material, such as benzine, L.P. gas, alcohol etc., into this unit.
6. Take precautions against leakage of any gas equipment near this unit.
7. Keep chidren from hanging on the door of this unit.
8. Do not reinsert the power supply cord within 5 minutes after releasing it from the
socket. If not, there may be problems with the compressor.
9. Put food in the refrigerator after running the refrigerator for 2~3 hours.
Take a moment to know all the features designed for the convenience of the user.
■ Ice tray
Fill 3/4 of the ice tray with water, as the volume expands when the water is frozen. Place
the tray in the freezer compartment. To release ice cubes, twist the ice tray slightly. Ice
cubes will be easier to remove if it is held for a short while under running water.
■ Movable refrigerator and freezer shelves
Storage shelves should be adjusted depending on the height of the food stored. To do this,
pull the shelves slightly forward.
■ Defrost-drain Vessel
Since dust accumulated on the drain case decreases the evaporation efficiency, you
should clean the drain case at regular intervals.
■ Vegetable case
May be used for fruit and vegetable storage. Both the vegetable case and its cover shelf
are removable for easy cleaning. Simply slide forward to remove.
■ Utility Pocket (Top)
The Egg Case in this pocket can be turned upside down for the use of small size goods.
Location
Install the refrigerator in a convenient location away from extreme heat and cold. Allow
at least 6cm clearance between the refrigerator and side wall so that the door may open
for a fully usable interior and the refrigerator may have good air circulation. The
refrigerator is not designed for recessed installation.
■ Select a strong and level floor.
■ Keep 6cm of space between the refrigerator and the walls.
Here are the features of your new refrigerator.
HOW TO INST ALL
6
1
1. Remove COVER on the right top of the cabinet.
2. Remove three bolts that hold HINGE to the
cabinet.
3. Lift DOOR and place it on a padded surface to
prevent scratching it.
2
1. Remove two bolts from HINGE on the right middle
of the cabinet and keep them for later use.
2. Remove HINGE.
3. Remove DOOR from the cabinet lifting up slightly.
4. Lift DOOR and place it on a padded surface to
prevent scratching it.
3
1. Remove two BOLTS from HINGE.
2. Take off HINGE from the cabinet.
3. Unscrew HINGE PIN and move to opposite
side.
4. Fasten it on the left bottom of the cabinet with
the three bolts previously removed.
4
1. Remove screw from stopper at the bottom of
DOOR.
2. Take it off and rotate, transfer to the other side
and fasten with screw.
Changing Reversible Door
This refrigerator has been built with the door hinges on the right.
If you wish to change the opening direction, follow the instruction below.
- Unplug the refrigerator from its electrical outlet.
- Empty everything in the refrigerator, including shelves, foods, etc.
5
CAUTION
Improper use of the grounding plug can result in electric shock. If a grounding adapter
is used, make sure the receptacle box is fully grounded.
POWER CORD REPLACEMENT
If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a simmilary qualified person in order to avoid a hazard.
When not operating for a long time
■ Remove the power supply cord.
■ Dry your refrigerator by opening the door for 2-3 days.
When you get ready to move
■ Securely fasten movable interior parts (or remove and pack them separately).
■ DO NOT lay down your refrigerator horizontally, or the compressor may be damaged.
If the refrigerator is not operating:
■ Is the power supply cord unplugged?
■ Is the home fuse or circuit out of order?
If the refrigerator is warmer than usual:
■ Has the door been opened frequently or for a long period?
■ Are there any hot food or anything that has been stored without cooling?
■ Is the clearance between the refrigerator and the wall given sufficiently?
If there are unusual sounds:
■ Is the refrigerator placed on a levelled floor?
■ Are there any foreign objects behind the refrigerator?
■ Are dishes on refrigerator shelves vibrating?
Before you call for service, please check the following points first.
WHA T TO DO...
7
5
1. Remove two bolts from STOPPER at the
bottom of DOOR.
2. Take off STOPPER and move to the opposite
position and fasten it.
CAP SCREW
6
1. Remove cap from left side and place it on
the right side where middle hinge was.
2. Put DOOR on the cabinet and fasten HINGE
with two bolts.
3. Leave the screw cap in the current
position(left) to prevent the rubbing the
freezer door gasket and screw cover when
the middle hinge is replaced.
7
1. Put DOOR on the cabinet and fasten HINGE
with three bolts and replace COVER
previously removed.
MODEL NO
Before operating this
refrigerator, please
read this manual
carefully.
UF950
REFRIGERATOR
Instruction Manual
CFC-FREE
Ultra Frost
Loading...