
RC-406
VACUUM CLEANER
OWNER’S
MANUAL
READ AND SAVE THESE INSTRUCTIONS
■ Thank you for purchasing this vacuum cleaner.
■ For proper operation, please read this manual carefully before using.

Contents
Description.....................................................................................2
Precautions for safe use................................................................ 3
How to use .....................................................................................4
Trouble shooting............................................................................8
1
Specifications
Rating AC 220V 50Hz
Watts 1,000 W, MAX. 1100 W
Dimensions 482 x 270 x 234 mm
Weight 7.5 Kg
Cord Lenght 5.0 m

OFF
POWER
CONTROL
Dusting brush
Crevice tool
Hose handle grip
Power control plate
Extension pipes
Suction hose
Suction hole cover
Wide suction brush
Cord rewind
button
Carrying
handle
Body
Dust bag holder Dust bag
Dust box

3
■ Plug the power cord into a 220V AC 50Hz
receptacle outlet.
To plug or unplug, grasp the plug body. Do
not hold or pull by the cord.
■ Use the carrying handle in moving the
cleaner around. Do not pull by the hose.
■ Do not vacuum areas which contain moisture or water.
■ Do not vacuum an inflammable matter, needles, pins, razor blades, etc.
■ Keep the cleaner away from heat sources.
■ Do not pull the power cord out beyond the
red indicator.
■ When rewiding the power cord, hold the
plug body before pressing the cord rewind
button to prevent whipping.
Precautions for Safe Use

How to Use
1. How to insert the hose into the suction hole.
2. How to attach the nozzle, brush, and extension pipes
3. How to attach the crevice tool into the pipe.
4. How to change/empty dust bag
4
• Open the cover and take out
the dust bag holder and
dust bag.
• Press the dust bag holder
locks to release the dust
bag.
• Empty the dust bag.
• Open the hole cover. • Insert the hose into hole firmly.
• Align the projecting part with the groove
and insert.
• By inserting the crevice tool into the pipe.
• Then turn the ring clockwise or in the
direction of the arrow.
Ring

5. How to insert dust bag.
6. How to clean the dust box.
7. How to clean stairs.
• Rest vacuum cleaner firmly on an upright position, one step below the next step being cleaned.
• Move vacuum cleaner one step at a time and continue cleaning.
8. How to move and store cleaner.
• Always pull or carry the unit using the handles when moving.
• The vacuum cleaner can be stored in an upright position to save space.
5
• Place dust bag neck on slots
at the dust bag holder.
• Press the dust bag holder
locks while pushing dust bag
neck in.
• Place dust bag holder into
dust box and close cover.
• Open the cover and
take the dust box out.
• Shake the dust off the
box.
• Wash the dust box
with water.
• Dry the dust box
completely, and then
use it again.

9. How to operate this cleaner.
■ An power control switch is located on the hose handle.
■ Adjust power control switch according to the place to be cleaned.
■ The power control switch can be set to CARPET, FLOOR, SOFA, and CURTAIN.
6
• Cleaning carpet
• Cleaning floor
• Cleaning sofa/table
• Cleaning curtain
FLOOR
SOFA
POWER
CONTROL
OFF
POWER
CONTROL
OFF
CURTAIN
POWER
CONTROL
OFF

10. How to use the wide suction brush.
• When cleaning carpet, set the lever to
CARPET.
• When cleaning floor or flat surfaces, set the
lever to NORMAL.
11. How to use the crevice too.
• The crevice tool is used to clean difficult to
reach narrow spaces between furnitures,
walls and floor.
12. How to use the dusting brush.
• For cleaning lamp fittings, picture rails, curtains and other delicate material.
7

13. Dust meter.
When the green indicator of the dustmeter is still
visible, just continue cleaning when the red indicator of the dustmeter apears, please empty or
change the paper bag.
Trouble shooting
■ Before Asking for Service, please check each item below if you have trouble with your cleaner.
8
NOTE: When cleaning with the crevice tool,
the red indicator may appear. In this
case you may continue cleaning.
Problem Check Point Measure
Suction power is weak • Dust box If dust box is full clean it.
• Air Flow control valve Adjust to right level.
• Pipe or hose If clogged or blocked remove object.
The motor will not start. • Power control switch Make sure to place the power control
switch to the curtain postion over.
• Power cord Check if power cord is plugged.
• Suction hose Check if hose is attached firmly
into suction hoe.
Power cord will not rewind Power cord Pull the power cord out a little and
press the cord rewind button.