Page 1
VACUUM CLEANER
RC-200
READ AND KEEP THIS
• Thank you for purchasing this vacuum cleaner.
• For proper operation, please read and this manual before use.
OWNER’S MANUAL
CONTENTS
•Description and operation
.....................................
2,3
•Cleaning the filter and Changing the dustbag
...........
4
•Precaution for safe use
.............................................
5
•Specifications
...........................................................
6
•Before asking for service
...........................................
6
Page 2
WIDE SUCTION NOZZLE
2
DESCRIPTION AND OPERATION
EXTENSION PIPE
• The control button enable you
to control tube’s length.
SUCTION CONTROL
• The suction control at the hand
grip enable you to control
suction.
POWER
CONTROL
MAX
STOP
• Use this nozzle for cleaning both
carpeted and uncarpeted floors.
ACCESSORIES HOSE CONNECTION
Floors Carpet
Dusting BrushCrevice Nozzle
• Adjust power control switch
according to the place to be
cleaned.
DUST METER
• When the color of the dust meter is changed to RED for long
time, change the dust bag.
• Connecting the hose: Insert the hose firmly into the hose inlet.
Disconnecting the hose: Press the button and pull the hose
out of the vacuum cleaner.
RED
Page 3
POWER CORD
3
CORD REWIND
• Rewind the power cord by
pressing the cord rewind
button.
• When you pull the cord out,
you must hold the plug.
STORAGE
HOSE CONNECTION
Cover
Handle
Hose
DUST METER
RED
• If oun want to store the
cleaner, hitch the pipe hold
onto the vacuum cleaner.
e hose: Insert the hose firmly into the hose inlet.
out of the vacuum cleaner.
Page 4
4
CHANGING THE DUST BAG
CHANGING THE FILTER
• Open the cover. • Push the bag holder to the
arrow mark, and then take the
dust bag out.
• Dispose the dust bag which
contains dust in a dustbin.
• Open the cover, and pull the
filter case out from the gasket.
• Shake the dust out of the filter. • Insert it again originally.
231
54
Bag holder
Note: If no dust bag has been placed into the dustbag holder, the cover can not be closed.
• Insert the dust bag to the slit and the hole of the
dust bag to the rubber whit pushing the bag
holder to thee arrow mark. Then fix the dust bag
by releasing the bag holder.
• Close the cover. At this time, it the dust bag is
not inserted properly, the cover would not be
closed completely.
Bag holder
Slit
Page 5
5
• Do not vacuum areas which contain moisture
or water and inflammable matter, needles,
pins, razor blades, matches, cigarette-ends,
etc., since they may damage the cleaner or
dust bag or cause a fire.
• Make sure a dust bag and a motor protection
filter are always inserted.
• When rewinding the power cord, hold the plug
body before pressing the cord rewind button to
prevent whipping.
• Do not pull the power cord out beyond the
specified length.
• This product provided with a cable which, if
damaged, must be replaced by a repair shop
authorized by the manufacturer since special
tools are required.
This vacuum cleaner should only be used for normal dry household dust and dirt.
The manufacturer cannot be responsible for any damage caused by use or operation of the cleaner
contrary to these instructions.
If the cleaner is wrongly operated for a purpose other than that for which it is intended, no liability can be
accepted for any possible damage.
PRECAUTIONS FOR SAFE USE
Page 6
6
■ Before Asking for Service, please check each item below if you have trouble with your cleaner.
BEFORE ASKING FOR SERVICE
Problem
Suction power is weak.
The cleaner does not work.
Power cord does not rewind.
Check Point
• Dust bag
• Pipe or hose
• Power cord
• ON/OFF switch
• Power cord
Measure
If dust bag is dirty, replace it.
If clogged or blocked, remove the object.
Check if power cord is plugged.
Check if the power switch is turned on.
Pull the power cord out a little and press
the cordrewind button.
• Specifications can be changed for improvement without notice.
Model
Rating
Watts
Weights(Net)
Dimension (L X W X H)
Cord Length
RC-200
240V/50Hz
120W, MAX 1500W
5.3kg
300X 270X 215mm
6m
SPECIFICATIONS
Loading...