4
W ARNING
Location
3
HOW TO INSTALL
Cleaners:
The cleaners noted below are availab le . Ne v er use harsh, abrasiv e
cleaners, heavy-duty cleaners, or solv ents on an y surf ace.
Exterior:
Wipe with damp, suda y cloth, rinse and dry. For stubborn stains 
and for periodic waxing, use silicon wax.
Refrigeration Section:
Wash shelves, drawers and other removable parts in 
warm sudsy water, rinse and dry. Wash interior with baking soda 
solution (3 Table spoons to one quart of water) or warm sudsy water.
Magnetic Door Seals:
Wash with warm sudsy water.
The finishing T ouch:
Replace all parts, and return TEMPERA TURE
CONTROL to desired temperature.
Leveling
Install refrigerator in a convenient location a way from extreme heat and cold. Allow 
sufficient clearance between the refrigerator and side wall so it is easy for 
refrigerator to radiate heat. Refrigerator is not designed for recessed installation.
Level refrigerator so it rests solidly on the floor, without rocking. There are two 
Adjustable foot one at each front corner. Turn to the left to raise a corner, to 
the right to lower it. Use shims under rear corners, if necessary .
 If you want, the refrigerator door to close when not held open, adjust glides
so that the front of the refrigerator is raised. However, front corners must 
be level with each other, and rear corners with each other.
 If you want the refrigerator door to remain motionless when open, adjust
the leveling glides so that all f our corners are le v el with each other .
NOTE:Make sure all packing material is remov ed. If the shipping tape has
left a residue on the door, touch the residue lightly with the 
adhesive side of tape of with isopropyl alcohol (most rubbing 
alcohol is this type).
Do not use a solvent, such as lighter or cleaning fluid, nor an 
abrasive cleanser .
BEFORE CLEANNING THE REFRIGERATOR FOR YOUR SAFETY, PLEASE 
DISCONNECT THE POWER PLUG FROM THE PO WER SOURCES.
HOW TO CLEAN
METHODS OF SAFE INSTALLATION
1. SAFE INSTALLATION PLACE FOR YOUR REFRIGERATOR
• Place the refrigerator
on hard and level 
floor.
• Place your refrigerator
where there is no heat 
source nearby. 
High surrounding 
temperatures will lower 
cooling efficiency and 
increases your 
electricity bill.
• Place the refrigerator
in an area with low 
moisture. 
Splashing water or a 
high moisture area 
may cause a short 
circuit and make 
rusting easier.
• Avoid places that are
exposed to smoke . 
The discolouring can 
occur to the refrigerator.
• For good ventilation
place refrigerator with 
the spaced specified 
on the figure. 
This helps to cooling 
efficiency and lowers 
the electricity bill.
• Placing the refrigerator
on the carpet may 
cause heat to develop 
and discolir the 
appliance. In such a 
case put a hard 
wooden board or a 
rubber mat between 
the refrigerator and the 
carpet.