HOW TO OPERAT
NAMES OF THE PARTS
1. EVAPORATOR : The heart of the refrigerator.
It evaporates the refrigerant fluid and thereby
absorbs heat from the surrounding. Made of pure
aluminum.
2. DRAIN PAN : Discards the water that drips of the evaporator
when defrosting.
3. CONTROL BOX Regulates the operation of the motor and controls
the inside temperature of the refrigerator.
4. PLASTIC COATED SHELF Has full width and can slide out.
5. MAGNETIC DOOR SEALS Keeps the refrigerator virtually airtight all
along the edge, but is nevertheless easy to open.
6.
ICE CUBE TRAY
: Ice cubes are easy to remove from the tray.
7. BOTTLE RACK for bottles, cans or jars.
8. USABLE RACK for cans or jars.
9. EGG SHELF for eggs.
1. Clean the refrigerator thoroughly. Wipe the outside with a soft dry cloth, the
inside with a damp cloth.
2. Keep the door open and insert the power supply cord into the socket.
3. Turn the thermostat dial to “7”. Close the door and let the refrigerator
operate for 15-20 minutes.
The freezer should then show some traces of frost.
HOW TO CLEAN
Starting your new Refrigerator
You can control the inside temperature by
turning the thermostat dial. Higher numbers
mean greater cooling power, smaller numbers
mean less cooling power. To make ice cubes
in the freezer compartment, set the dial to “7”.
The dial does not have to be set exactly on the
numbers, but can be any place in between.
T emperature control
Defrost the refrigerator when the frost accumulated on the evaporator is
about 5mm(1/5inch) thick.
Set the thermostat dial to “0”. Remove foods. Keep drip tray in place.
Defrosting usually takes a few hours. To defrost quickly remove all foods
from the refrigerator and leave door open. Never use a knife or other metal
instrument to remove ice/frost from the evaporator. After defrosting empty
water from drip tray, return the thermostat dial to the desired position to
start refrigerating again.
How to defrost
NOTE: Wait 3 to 5 minutes before restarting if you unplug the
machine. Unit may fail to operate properly if restarted too
quickly.
HOW TO OPERATE
7
0
1
TEMPERATURE
CONTROL
C
O
L
6
2
D
E
5
R
4
3
HOW TO CLEAN
Cleaners: The cleaners noted below are available. Never use harsh,
abrasive cleaners, heavy-duty cleaners, or solvents on any surface.
Exterior: Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains
and for periodic waxing, use silicon wax.
Evaporator: When refrigerator needs defrosting turn thermostat dial to
“OFF”. Do not use sharp instruments.
Refrigeration Section: Wash shelves and other removable parts in warm
sudsy water, rinse and dry. Wash interior with baking soda solution (3
table spoons to one quart of water) or warm sudsy water, rinse and dry.
Magnetic Door Seals: Wash with warm sudsy water.
The Finishing Touch: Replace all parts and return thermostat dial to
desired setting.
HOW TO INSTALL
§ Install refrigerator in a convenient location away from extreme heat and
cold. Allow sufficient clearance between the refrigerator and side wall so
the door will open for a fully usable interior. Refrigerator is not designed
for recessed installation.
§ Select a place with strong level floor.
§ Allow 5 inches of space between the refrigerator’s side and the wall.
5
inches
WHAT TO DO...
1. When out of operating for a long time:
§
Remove the power supply cord.
§
Dry your refrigerator opening the door for 2-3 days.
2. When you get ready to move:
§
Securely fasten removable interior parts (or move and package them
separately)
§
Do not lay your refrigerator horizontally, or compressor may be damaged.
When you need service: Before you call for service make
sure you need it, check a few things noted below for
yourself first.
If refrigerator is not operating:
§
Is the power supply cord unplugged?
§
Is home fuse blown or circuit breaker off?
If refrigerator is warmer than usual:
§
Has the door been open frequently or for a long period?
§
Is refrigerator overcrowded-preventing good air circulation?
§
Is the hot thing stored without cooling?
§
Is the clearance between refrigerator’s side and the wall allowed
sufficiently?
If there are unusual sounds:
§
Is refrigerator placed on the level?
§
Are foreign objects behind the refrigerator?
§
Are dishes on refrigerator shelves vibrating?
If so, rearrange the dishes.
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a simmilary qualified person in
order to avoid a hazard.
§
Before use, please read this manual carefully.
§
Always remove the drain pan while this refrigerator is running.
§
Removing the drain pan will enhance the cooling power and
save your electric cost.
Model No.: ER-090
REFRIGERATOR
INSTRUCTION MANUAL
CFC-FREE
Loading...