Daewoo DP-ST21, DP-ST20 User Manual

S T A N D
PLASMA MONITOR (DISPLAY)
STAND
INSTRUCTION MANUAL
DP-ST22 DP-ST21 DP-ST20
1
TABLE OF CONTENTS
1. Check for enclosed parts
............................
1
2. Important Safety Instructions
......................
2
3. Assembly Instructions
.................................
3
4. Disassembling Instructions
.........................
5
1. PLEASE CHECK FOR THE ITEMS SHOWN BELOW
(1)
STAND M5 SCREWS
(2)
PLASMA DISPLAY STAND
2
S T A N D
2. IMPORTANT SAFETY INSTRUCTIONS
PLEASE KEEP THESE INSTRUCTIONS FOR YOUR SAFETY AND TO PREVENT ANY DAMAGE TO THIS UNIT.
PLEASE FOLLOW THESE INSTRUCTIONS FOR YOUR SAFETY
(If screws come loose, it can result in an electric shock and unwanted accident)
(Doing so may cause the unit to fall and break)
(If the unit is dropped, it may result in damage to the unit and injury to your person)
(It may result in unwanted marks on the units, if working without the protective covering)
When assembling, be sure to use the enclosed parts and make sure all parts are tightly screwed.
When assembling, do not alter or modify any parts
When installing, be sure to have at least two people handling the unit.
When attaching stand to plasma display, be sure to cover the surface to protect from accidental damage.
WARNING
CAUTION
WARNING : Disregarding
these instructions can result in serious injury.
CAUTION : Disregarding these instructions will result in the mistreatment of the unit and can result in injury or damage to the unit.
When handling Display glass, be careful not apply any pressure on it.
3
3. ASSEMBLING INSTRUCTIONS
HOW TO DISPOSE OF THE PLASMA MONITOR WRAPPER
HOW TO DISPOSE OF THE PROTECTIVE CAP.
.
First dispose of the wrapping band and raise the top box to open.
.
Afterwards, dispose of the Styrofoam and remove the vinyl covering.
.
Place a protective covering over the
surface you will be working on and lay the plasma display as shown below.
.
As shown below, unscrew the screws and take out both of the protective caps.
1
2
PLASMA DISPLAY STAND
4
S T A N D
.
Open and take out the stand from the
box and remove wrapper.
.
Slide the stand under the plasma display like the picture below.
.
Use the enclosed 2 M5 screws to secure the assembled stand.
(Picture of a properly installed stand and display)
ASSEMBLING THE PLASMA DISPLAY STAND
3
M5 Screws
5
4. DISASSEMBLING INSTRUCTIONS
.
Place a protective covering over the
surface you will be working on and lay the plasma display as shown below.
.
Completely unscrew the secured 2 screws.
.
Pull the stand away from the plasma display to disassemble.
DISASSEMBLING PLASMA DISPLAY STAND
Loading...