FEATURE CHART
Here are the features of your new refrigerator.
Take a moment to know all the features and convenience it was designed to provide.
Numbers match those in the illustration on page 1.
■ Ice tray
Fill tray 3/4 full to allow expansion of water during freezing. Place tray in freezer chest. To release cubes, twist lid slightly.
■ Removable shelf
Shelves can be removed by pulling forward. The shelf can be placed at your desirable position.
■ Freezer Shelf
To remove the freezer shelf!
1. Remove the screw on the left of inside freezer shelf with screw driver.
2. Push the shelf hooks to the back slightly and remove it by lifting off the slots of bottom side.
3. Reverse procedure to install.
■ Defrost Drain Vessel
To remove defrost drain vessel.
1. Lift the defrost drain vessel slightly, then rotate bottom out and pull it down. 2. Reverse procedure to install.
FREEZER DOOR GASKET |
REFRIGING-ROOM POCKET(SMALL) |
FREEZER POCKET |
REFRIGING-ROOM POCKET(LARGE) |
FREEZER REMOVABLE SHELF |
LAMP COVER |
FREEZER TEMPERATURE |
REFRIGERATOR TEMPERATURE |
CONTROL KNOB |
CONTROL KNOB |
ICE TRAY |
REMOVABLE SHELF (LARGE) |
ICE BOX |
GLASS SHELF |
REFRIGING-ROOM DOOR GASKET |
VEGETABLE BOX |
EGG POCKET |
CHILLED TRAY |
1 |
2 |
■ Lamp Cover
To remove lamp cover
1.Push up the bottom ends of lamp cover gently, then pull out.
2.Reverse procedure to install.
■Vegetable Crisper
May be used for fruit and vegetable storage. Both the crisper and its cover shelf are removable for easy cleaning. Simply slide forward to remove.
■ Egg Pocket
Egg supporter in this pocket can be turned upside down.
May be used for small size goods.
1.Check your voltage before inserting the power supply cord into the socket.
2.Contact the earthing conductor to this unit with an attachment earthing screw.
3.Don’t make it spill to this unit.
4.Don’t work with flammable spray, such as painting, near this unit.
5.Don’t put ignitable materials, such as benzine, L.P. Gas, alcohol, etc., into this unit.
6.Precaution to the leakage of any gas equipment near this unit.
7.Precaution not to hold on to the door of this unit by children.
8.Precaution not to reinsert the power supply cord within 5 minutes after release it from socket. If not, a trouble may be occured to compressor.
METHODS OF SAFE INSTALLATION
1. SAFE INSTALLATION PLACE FOR YOUR REFRIGERATOR
• Place the refrigerator |
• Place your refrigerator |
• Place the refrigerator |
on hard and level |
where there is no heat |
in an area with low |
floor. |
source nearby. |
moisture. |
|
High surrounding |
Splashing water or a |
|
temperature will lower |
high moisture area |
|
cooling efficiency and |
may cause a short |
|
increases your |
circuit and make |
|
electricity bill. |
rusting easier. |
•Avoid places that are exposed to smoke. The discoloring can occur to the refrigerator.
•For good ventilation place refrigerator with the spaced specified on the figure.
This helps cooling efficiency and lowers the electricity bill.
•Placing the refrigerator on the carpet may cause heat to develop and discolor the appliance. In such a case put a hard wooden board or a rubber mat between the refrigerator and the carpet.
3 |
4 |