ILHSF8, ILHSF10
13”
(33.0 cm)
6 ½"
(16.5 cm)
13 ¼"
(33.6 cm)
16 ½"
(41.9 cm)
13”
(33.0 cm)
8 3/16”
(20.8 cm)
8” REF.
(20.3 cm)
6”
(15.2 cm)
2 ¼”
(5.7 cm)
8” REF.
(20.3 cm)
3/16” (0.5 cm)
15 ¾”
(40.0 cm)
9 1/8"
(23.2 cm)
15 ¼"
(38.7 cm)
19”
(48.3 cm)
16”
(40.6 cm)
2 ¼”
(5.7 cm)
10 ¾”
(27.3 cm)
8 ¼”
(21.0 cm)
10” REF.
(25.4 cm)
10” REF.
(25.4 cm)
3/16” (0.5 cm)
Revised
06/17/08
Inline Blowers
PLANNING
1/2
All tolerances +1/16” -0 (+1.6 mm, 0) unless otherwise noted.
WARNING
Observe all governing codes and ◊
ordinances during planning and installation.
Contact your local building department for
further information.
This appliance must be installed in ◊
accordance with the accompanying
installation instructions.
GUIDE
ILHS8 OVERALL DIMENSIONS
Web: http://www.Dacor.com
Corporate Phone: 800-793-0093
ILHSF10 OVERALL DIMENSIONS
Specifications are subject to change without notice.
See installation instructions for additional details.
9.6
ILHSF8, ILHSF10
Revised
06/19/08
Model
Number*
ILHSF8
ILHSF10
* All models are thermally protectd
** In addition to the hood or raised vent
*** At 0 inches static pressure
Power
Requirements**
120 Vac, 60 Hz,
3.5 Amp
120 Vac, 60 Hz,
4.5 Amp
Blower Rating***
Inline Blowers
600 CFM
1200 CFM
NOTE:
1. The above specifications are for reference
only. See the data label on the blower for exact
specifications. If the above specifications vary
from the label on the blower, use the data on the
blower label.
PLANNING
2/2
WARNING
To avoid the risk of fire due to the unit overheating:
DO NOT◊ install this blower with a hood or raised vent
that has an internal blower.
DO NOT◊ install more than one blower to increase the
length of the duct run. Even small differences between
blower air flow rates can greatly reduce the air draw by
the hood or raised vent.
GUIDE
Knock-out
ELECTRICAL ACCESS KNOCK-OUTS
Model Number Weight
ILHSF8 22 lbs. (10 kg.)
ILHSF10 31 lbs. (14 kg.)
Knock-out
Web: http://www.Dacor.com
Corporate Phone: 800-793-0093
Specifications are subject to change without notice.
See installation instructions for additional details.
9.7