HRTP366, HRTP486
Heritage
Slide-In Gas Rangetop
®
36”, 48” Wide
Doc #: PGH-HRTP.01 Revised 22 May 2018 Page 1 of 3
All tolerances: ±¹/₁₆” (±1.6 mm), unless otherwise stated.
PLANNING
GUIDE
HRTP Dimensions
WARNING
• Observe all governing codes and
ordinances during planning/installation.
(Contact the local building department
for details.)
• The rangetop must be installed as
instructed in this guide.
Chassis Width
Model A
HRTP366 35 ” (91.1 cm)
HRTP486 47 ” (121.6 cm)
Model B C
HRTP366 36” (91.4 cm) 36” (91.4 cm)*, 42” (106.7 cm)**
HRTP486 48” (121.9 cm) 48” (121.9 cm)*; 54” (137.2 cm)**
* Minimum ** Recommended
Note Description
1 Measured from top of grate to combustible surface.
2
See Cabinet/Countertop Cutout Dimensions, Pgs. 3 – 4.
3
Not applicable for cabinets more than a horizontal distance
of 10” (25.4 cm) from edge of rangetop.
All specications subject to change without notice. www.dacor.com Ph. 800.793.0093
HRTP366, HRTP486
Heritage
Slide-In Gas Rangetop
Cabinet/Countertop Cutout Dimensions
®
36”, 48” Wide
Page 2 of 3
All tolerances: ±¹/₁₆” (±1.6 mm), unless otherwise stated.
PLANNING
GUIDE
Model B (Cutout Width) D (Hole Offset)
HRTP366 36” (91.4 cm) 16 ” (42.2 cm)
HRTP486 48” (121.9 cm) 20-¹³/₁₆” (52.9 cm)
NOTE:
The power cord and gas-supply conduit may
be routed through the bottom or back of the
rangetop chassis.
All specications subject to change without notice. www.dacor.com Ph. 800.793.0093
Loading...