Dacor ERD60, AESP03, ERD30, ERD60LP User Manual
ERD60
27" (686mm)
26" (660mm)
28 1/2" (724mm)
37”
(940mm)
to
35 3/4"
(908mm)
Finished Side Panel
24 3/8" (619mm)
Rear of Control Panel/Oven Door
Face of Control Panel/Oven Door
Front Edge of Bullnose
Handle
6” (152mm) Backguard
When Backguard and
Side Panels are
removed, the overall
depth decreases
by 1" (25mm)
Accessory 3” (76mm) Side Panels
(Dacor Model No. AESP03)
1 9/16"
(40mm)
Power Cords
60" (1524mm)
Factory installed 3/4” regulators
(1/2” supply ok)
6" (152mm)
Backguard
Revised
06/25/08
60” Wide,
Epicure® Range
Observe all governing codes and ordinances during ◊
planning and installation. Contact your local building
department for further information.
This appliance must be installed in accordance with the ◊
accompanying installation instructions.
PLANNING
1/2
WARNING
GUIDE
1. Utilities may be located in the lower left corner of
2. Contact your local building department to verify
3. Two electrical circuits and gas supplies required.
ERD/EGR30, ERD60 OVERALL DIMENSIONS
SIDE VIEW
NOTES:
the adjacent right cabinet. (Recommended)
Dacor®
Model No.
ERD60
ERD60LP Liquid
*Two separate dedicated circuits are required, one for left and one for the right side of the range.
compliance with local code interpretation.
REAR VIEW
Dedicated Circuit*
Required
240 Vac, 4-wire, 60 Hz,
30 Amp (Breaker) X2
Total
Connected
Load
4.1 kW
(21Amp) X2
Gas
Type
Natural 5” Water Column 6” Water Column
Propane
ELECTRICAL AND GAS SUPPLY REQUIREMENTS
Manifold
Pressure
10” Water Column 11” Water Column
Min. Gas Supply
Pressure
Web: http://www.Dacor.com
Corporate Phone: 800-793-0093
Specifications are subject to change without notice.
See installation instructions for additional details.
5.7
ERD60
**
** Cabinet depth is at discretion of customer
but cabinet face MUST NOT protrude further
than rear of front panel, see product dimesions
* Vertical to combustible surface
B
A
Non-Combustible
surface along
back wall
Suggested
location of
utilities
30” (762mm)
min.*
59 1/4" (1505mm)
60 1/8" (1527mm)
3/4" (19mm)
Max. backsplash
1/4" (6mm)
Min. flat ledge
13/16" (21mm)
23 3/16"
(589mm)
Vertical
non-combustible
surface
Rear wall
25”
Countertop
Countertop
Revised
06/25/08
60” Wide,
Epicure® Range
Model Number “A” Cutout Width “B” Hood Width
ERD60 60 1/8” (1527mm)
PLANNING
2/2
Minimum
CUTOUT DIMENSIONS
66” (1676mm) Recommended
GUIDE
60” (1524mm)
COUNTERTOP CUTOUT DIMENSIONS
(Slide-In, Freestanding Installation)
NOTE:
1. When backguard is removed, the side panels must
be removed.
(Slide-In, Self-Rimming Installation with Side Panels and Backguard Removed)
CUTOUT DIMENSIONS
Web: http://www.Dacor.com
Corporate Phone: 800-793-0093
Specifications are subject to change without notice.
See installation instructions for additional details.
5.8
Loading...