Dacor EO230, MOV230, MOH227, MOV227, MOH230 User Manual
EO, MOH, MOV
Document # PG01-002 Revised 01/25/11 Page 1/2
27 and 30 Inch Wide, Double,
Discovery Wall Ovens
WARNING
• Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
• This appliance must be installed in accordance with the
accompanying installation instructions.
Product tolerances: ±1/16” (±1.6 mm), unless otherwise stated.
C
1 1/4”
(3.2 cm)
E
F
PLANNING
Dedicated Circuit
Required
240 Vac,
4-wire*, 60 Hz, 50 Amp.
* Two 120 Vac hot (L1 and L2), one neutral, one ground.
Top of
chassis
H
D
Total
Connected Load
9.25 kW (38.9 Amp.) 415 lbs.
GUIDE
Approximate
Shipping Weight
B
27”
30”
L
(129.7 cm)
J
K
51 1/16”
Top of
chassis
A
23 3/8”
(59.4 cm)
2 5/16”
(5.9 cm)
Control panel
front
Chassis notch
side view
Model A B C D E F G H J K L
EO227
MOH227
MOV227
EO230
MOH230
MOV230
(68.6 cm)
(76.2 cm)
Utility
cutout
7 3/8”
(18.7 cm)
G
66” (167.6 cm)
Flexible conduit
6 3/8”
(16.2 cm)
50 1/2”
(128.3 cm)
22 11/16”
(57.6 cm)
25 3/8”
(64.4 cm)
9/16”
(1.4 cm)1”(2.5 cm)
28 3/8”
(72.0 cm)
1 7/8”
(4.6 cm)
PRODUCT DIMENSIONS
Specications subject to change without notice. Phone: (800) 793-0093www.Dacor.com
1.7
EO, MOH, MOV
Document # PG01-002 Revised 01/25/11 Page 2/2
27 and 30 Inch Wide, Double,
Discovery Wall Ovens
Cutout tolerances: +1/16” (+1.6 mm), -0, unless otherwise stated.
C
Recommended
electrical
location
1“ (2.5 cm) min.
clear to
bottom of
door
A
PLANNING
GUIDE
EO - Epicure
3 11/16”
(9.4 cm)
HANDLE DIMENSIONS - SIDE VIEW
®
MOH/MOV - Millennia
3 5/16”
(8.4 cm)
1 1/4”
(3.2 cm)
1 1/4”
(3.2 cm)
®
1 ¾“ (4.5 cm) min.
clear to top of
door for heat
exhaust
B
3/4” (1.9 cm)
support platform
4“ typical toe kick (shown)
9 5/8” (24.4 cm)
recommended
(may be altered)
Model A B C
EO227
MOH227
MOV227
EO230
MOH230
MOV230
50 9/16”
(128.4 cm)
CUTOUT DIMENSIONS
25 1/2”
(64.8 cm)
28 1/2”
(72.4 cm)
27”
(68.6 cm)
30”
(76.2 cm)
NOTES:
1. 24” (61.0 cm) minimum interior cabinet depth. Back of
cabinet may need to be removed.
2. 3/4” (1.9 cm) support platform (flush with cutout).
3. 1/8” (3 mm) minimum clearance from appliance to
adjacent cabinet doors/drawers.
Specications subject to change without notice. Phone: (800) 793-0093www.Dacor.com
1.8
Loading...