Dacor DHD48, DHD36, DHD30 User Manual
DHDxx
Doc #: PGH-DHD.01 Revised 19 Sept 2018 Page 1 of 3
All tolerances: ±¹/₁₆” (±1.6 mm) unless otherwise stated.
Modernist 30”, 36", 48" Wide
General Specifications
All Models: DHD30/36/48
Features Description
Blower Speeds Four (4)
Filters Baffle style, dishwasher safe
Exhaust(s) 8” duct diameter
Total
Connected
Load
Lights
Individual Models: DHD30/36/48
Components 48” 36” 30”
30”, 36”: 120V, 60 Hz, 15 Amp (actual load 3.3 Amp, 6
Amp initial surge)
48”: 120V, 60 Hz, 15 Amp (actual load 6.1 Amp, 12 Amp
initial surge)
Dimmable LED: PAR16 E26/27; 120V, 7.5W (75W Max.
other bulbs)
Wall Hood
• Observe all local ordinances during planning and installation.
Contact your local building department for details.
• This unit must be installed according to its installation instructions.
Dimensions
Single Blower DHD30/36
PLANNING
WARNING
GUIDE
Lights
4 3 2
Filters
Blowers
2 1 1
Exhaust Vents
Blower Rating 1200 CFM 600 CFM 600 CFM
Weight Specifications
Individual Models: DHD30/36/48
Model Weight
30 53 lbs (24 kg)
36 57 lbs (26 kg)
48 77 lbs (35 kg)
Ventilation
Individual Models
Dual Blower DHD48
Model Top Vent Rear Vent Rotatable Fan
30 X X X
36 X X X
48 X X X
All specications subject to change without notice. www.dacor.com Ph. 800.793.0093
Model A B C D
30 29 ” (75.9 cm)
36 35 ” (91.1 cm)
48 47 ” (121.6 cm)
24”
(61 cm)
18”
(45.7 cm)
11 ”
(30.2 cm)
DHDxx
All tolerances: ±¹/₁₆” (±1.6 mm) unless otherwise stated.
Page 2 of 3
Modernist 30”, 36", 48" Wide
Wall Hood
Electrical/Duct Connections
Connect wiring/ducting through the top or rear of the hood. Before
installing the hood, mark the access holes per these diagrams.
Top Connections—All Models
PLANNING
GUIDE
Cabinet Layout Dimensions
Dimension: Top Electrical/Ducting Holes
Model A B C
48 1 ½ in. (3.81 cm) 5 in. (12.7 cm)
3 in. (7.62 cm)36 1 ½ in. (3.81 cm) 4 ½ in. (11.43 cm)
30 1 ½ in. (3.81 cm) 5 ½ in. (13.97 cm)
Rear Connections—All Models
Dimension: Rear Electrical/Ducting Holes
Model A B C
48 1 in. (2.54 cm) 5 in. (12.7 cm)
3 in. (7.62 cm)36 1 in. (2.54 cm) 4 ½ in. (11.43 cm)
30 1 in. (2.54 cm) 5 ½ in. (13.97 cm)
Min. Width of E (Upper-Cabinet Cutout, Appliance Width)
DHD Model E
30 30 in. (76.2 cm)
36 36 in. (91.5 cm)
48 48 in. (121.9 cm)
Planning the Ductwork
WARNING
• To prevent combustion by-products, smoke, or odors from entering
the home, and to improve efficiency, tape all duct joints securely.
• Range hoods may impede proper flow of smoke and combustion
gases from furnaces, gas waterheaters, and fireplaces. To avoid
drawing lethal gases into the home, follow manufacturer and NFPA/
ASHRAE directions for these devices.
• Failure to install a remote blower or proper ductwork may cause a
backdraft and insufficient venting of smoke/fumes.
• DO NOT add an in-line/external blower to the ducting. Even small
differences between blower air-flow rates can greatly reduce the
hood’s air draw.
All specications subject to change without notice. www.dacor.com Ph. 800.793.0093
Loading...