Cyron HTW1000 User Manual

9439 IRONDALE AVE., CHATSWORTH, CALIFORNIA 91311 USA

888-297-6660 www.CYRON.com

Media Highlighter® IR Controller

HTW1000

Hardwiring Instructions

Thank you for purchasing CYRON HTW1000 Media Highlighter IR controller.

a a a a

To hardwire this system you need ample knowledge of wiring practices.
This option should be done by experienced professionals such as
electricians or certified custom electronic installers. Please contact
CYRON Technical Support for further details. There may be other
options available for your project. CYRON experienced Tech Support
staff will be happy to help you implement your project.

STEP ONE: Open the HTW1000 controller box.

STEP TWO: Take out the PCB to gain access to the hub.

Use minimum 18AWGx4 (4 conductor 18 gauge) wire for extending lightbar
wires up to 100ft. For runs over 100ft you must increase the wire gauge
accordingly.

To minimize the clutter of too many wires at the hub, you should connect as
many lightbars possible to one or few main leads. The main leads can then be
connected to the terminal block.

STEP THREE: Take out the housing wire cap.

STEP FOUR: Connect wires to the hub following the color code shown in
Table One. Note that 12VDC and lightbars wires can all be connected to the
hub. Connecting the 12VDC directly to the hub is required for power supplies
over 60watts. Four terminal inlets have been provided for 12V positive and
negative. For power sources over 100W it is a good idea to use four wires, two
for the positive, two for the negative. This will eliminate extra current being
carried over one wire.

CYRON Media Highlighter Lightbar

CYRON Lightbar Wires
(Not the same as HTHUB wires)

HTW1000 Terminal Block

Green

+12V

Black

B

Red

G

White

R

HTHUB6 Hub Wire

HTW1000 Terminal Block

Black

+12V

Green

B

White

G

Red

R

Wire Color Code

TABLE ONE

STEP FIVE: Place the PCB back in their positions and close the back cover. Pay close attention to the
wires connecting the side PCBs to the main PCB.

STEP SIX: Manage the wires. Use zip ties or other means to secure the wires
together. As stated in the User Manual, the IR receiver will need to be connected
to the IR plug. The IR receiver needs to be in the line of sight in order for the
remote to work.

Keep the controller and wires away from extreme heat,
liquids, and moving objects.

Low voltage wires can be routed through walls and
cabinets as long as proper care is taken to avoid damages.

DO NOT modify internal components. Tampering with
components and wiring will void factory warranty.

For operations please see the User Manual. If you have any questions please contact CYRON Technical
Support at [e-mail] or 888-297-6660 x106.

Additional Notes:
It is also possible to hardwire the 6-outlet Media Highlighter Hub (Part# HTHUB6) to the HTW1000
terminal block. Table Two shows the wiring diagram.

Hardwiring the Media Highlighter Hub HTHUB6

TABLE TWO