Cydata Daisy User Manual

®

Wi-Fi Enabled

Thermostat

3:37 PM

Heat
Mode

30%

Auto
Fan

Set

78

INSTALL GUIDE

INSTALLING THERMOSTAT

INSTALLING THERMOSTAT

Important! Check wire terminal compatibility with User Guide before starting installation.

Inside your Daisy thermostat box.

3:37 PM

30%

1. Daisy Wi-Fi Thermostat

2. Thermostat Base

Heat
Mode

Auto
Fan

Set

78

3. Mounting Hardware

4. Quick Guide

5. Wiring Labels

1 Switch power OFF to your HVAC system.

Important! Switch the power OFF to your HVAC

systems at the breaker box or the system switch to
protect your system.

WARNING: This thermostat works with common 24 volt

system. It will not work with millivolt systems or with 120/240
volt systems such as baseboard electric heat.

NOTICE: To avoid possible compressor damage, do not run air

conditioner if the outside temperature drops below 50˚F (10˚C)

Circuit breaker box

OR

HVAC system

power switch

2 Leave wires connected and remove old
thermostat from wall.

Take photos of wire connections

to reference later on.

MERCURY NOTICE: Do not place your old thermostat in the

trash if it contains mercury. Contact the Thermostat Recycling
Corporation at www.thermostat-recycle.org or
1-800-238-8192 for information on how and where to
properly and safely dispose of your old thermostat.

3 Label the wires.

Do not label wires by color. Use the tags included
to label as you disconnect each wire. Wires should
be labeled according to your existing thermostat
terminal assignments, not by color.

Note: Blank tags are provided to write the terminal

label if you find no matching tags exist.

RC

R Y C

W

DAISY Wi-Fi Programmable Thermostat / INSTALL GUIDE 2