CyClone 205 User Manual

TRANSPONDER IMMOBILISER

USER INSTRUCTIONS

CYCL PS

VEHICLE SOLUTIONS

PROUDLY

AUSTRALIAN

TRANSPONDER IMMOBILISER

CYCL PS

VEHICLE SOLUTIONS

Security System

CYCLOPS PARALYSER 205

User Instructions

Congratulations on having one of the world's most advanced
and unique Australian designed and engineered vehicle security
systems, installed in your vehicle!

The Cyclops Paralyser 205 has been tested to and meets

Australian Standards 4601:1999.

DISARMING

To disarm the P205, simply switch on the vehicle's engine.
The small transponder tag attached to your key chain will
come in close proximity to the receiver antenna located below
the ignition switch. The P205 will decode the signal from the
tag and disarm. The red status LED will extinguish and the engine
can be started. If the engine is not started within 39 seconds the P205
will automatically re-arm.

ARMING

The P205 will automatically arm within 39 seconds of the ignition being
switched off.

ENGINE IMMOBILISATION

When the system is armed the engine is immobilised. The two independent,
normally open circuits of immobilisation ensures the engine is starved of either
fuel or spark. Immobilisation points vary from vehicle to vehicle; common
engine kill places include fuel injection, fuel pump, fuel cut-off solenoids, main
ignition feed, low-tension distributor supplies and starter motor solenoids etc.