Current Prime Chiller 2604, Prime Chiller 2606, Prime Chiller 2614, Prime Chiller 2616, Prime Chiller 2626 Instruction Manual

Prime Chiller

Modular Upgradable Chiller

Instructions for Models

Single Stage Thermostat #2604, 2606

Dual Stage Thermostat #2614, 2616

Single Stage Thermostat w/ TXV #2626, 2627

Warning and Safety Instructions ....... Page 2

Chiller Installation ....... Page 4

Temperature Controller Installation ....... Page 6

Programming Temperature Controller ....... Page 7

Troubleshooting/Maintenance....... Page 8

Warranty ....... Page 9

™

EMAIL:INFO@CURRENT-USA .COM

WW W.CURRENT-USA .COM

02-2007-JEE

Please read all instructions carefully

do not forget to register your

product at www.current-usa.com

In the event that you are experiencing trouble running your chiller,

please visit our website support section at www.current-usa.com or

contact Current-USA directly at 866-276-8872 for troubleshooting

assistance.

Please have the following information available:

Model Number of Chiller

Date and Place of Purchase

EMAIL:INFO@CURRENT-USA .COM

WW W.CURRENT-USA .COM

02-2007-JEE

Safety Instructions

WARNING

To guard against injury, basic safety precautions should be observed, including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

DANGER

To avoid possible electric shock, special care should be taken since water is employed in the use of
aquarium equipment. For each of the following situations, do not attempt repairs by yourself. Contact
Current-USA or discard the appliance.

• If the appliance falls into the water, or water drips onto the unit, DON’T reach for it! First
unplug it and then retrieve it. If electrical components of the appliance get wet, unplug the
appliance immediately.

• Always unplug appliance from an outlet when not in use, before putting on or taking off
parts, and before cleaning. Never yank cord to pull plug from outlet. Grasp the plug fully
and pull out to disconnect.

• Carefully examine the appliance after replacement. It should not be plugged in if there is
water on parts not intended to be wet.

• Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or
has been dropped or damaged in any manner.

• If you are using the ultraviolet sterilizer or heater upgrade do not operate the unit without
continual water flow.

• If you are using the heater option ensure that the heater is plugged into the thermostat that
is supplied with the water chiller.

• Exposing chiller/power cords to water may cause electrical short and fire.

• Do not allow water or salt to come in contact with thermostat or power cords.

• Do not operate chiller without water flow to the unit. This may cause the evaporator housing
to freeze up and result in damage to the unit.

• Failure to install the sensor into the sensor port may cause an inaccurate temperature
reading and may cause damage to the chiller.

SAVE THESE INSTRUCTIONS

GROUND FAULT CIRCUIT INTERRUPTER PROTECTION

To comply with the National Electrical Code (NFPA 70), and to provide additional protection from the
risk of shock, this unit MUST be connected to a ground fault circuit interrupter (GFCI) outlet at all times.
Do not use extension cords. WARNING – To reduce the risk of electrocution, keep all connections dry
and off the ground. Do not touch plug with wet hands.

3

WW W.CURRENT-USA .COM