Cuisinart FR-10 User Manual

INSTRUCTION AND RECIPE BOOKLET

TM

Cuisinart

For your safety and continued enjoyment of this product, always

Tazzaccino

read the instruction book carefully before using.

TM

Milk Frother

FR-10 Series

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions
should always be followed, including the following:

1. READ ALL INSTRUCTIONS.

2. Always unplug unit from outlet when not in use,

before putting on or taking off parts and before
cleaning. To unplug, grasp plug and pull from
electrical outlet. Never pull cord. Allow to cool
before handling.

3. To protect against risk of electric shock, do not put motor

base, power cords and plugs in water or other liquids.

4. Close supervision is necessary when any appliance

is used by or near children.

5. Do not operate any appliance with a damaged cord
or plug, after the appliance malfunctions, or if
appliance has been dropped or damaged in any
manner. Return the appliance to the nearest
authorized Cuisinart Service Facility for examination,
repair, and electrical or mechanical adjustment.

6. The use of attachments not recommended or sold
by Cuisinart may cause fire, electric shock or injury.

7. Do not let cord hang over edge of table or counter,
or touch hot surfaces.

8. Do not plug in or take out plug when your hands
are wet.

9. Do not use outdoors.

10. Do not touch hot surfaces.

11. Do not operate your appliance in an appliance garage
or under a wall cabinet. When storing in an appliance

garage always unplug the unit from the electrical
outlet. Not doing so could create a risk of fire,

especially if the appliance touches the walls of the
garage or the door touches the unit as it closes.

12. Do not use the appliance for other than intended use.

13. Where applicable, always attach plug to appliance and
check that the control is off before plugging cord into
wall outlet. To disconnect, turn the control to OFF, then
remove plug from wall outlet.

14. Do not place on or near a hot gas or electric burner,
or in a heated oven.

2

15. Be especially careful when opening the cover; the
contents in the unit tank can splash out.

16. Do not move the unit while it is switched on. While being
moved, hot liquid can escape from the unit.

17. Scalding may occur if the lid is removed during the
mid-cycle.

SAVE THESE
INSTRUCTIONS

FOR HOUSEHOLD
USE ONLY

SPECIAL CORD SET INSTRUCTIONS

A short power supply cord is provided to reduce the risks
of becoming entangled in or tripping over a longer cord.
Extension cords may be used if care is exercised. If an
extension cord is used, the marked electrical rating of the
extension cord should be at least as great as the electrical
rating of the appliance. The longer cord should be arranged
so that it will not drape over the countertop or tabletop, where
it can be pulled on by children or tripped over unintentionally.

NOTICE

This appliance has a polarized plug (one prong is wider than
the other). As a safety feature, this plug will fit into a polarized
outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified
electrician. Do not attempt to defeat this safety feature.

3

FEATURES AND BENEFITS

1. Transparent Cover with Seal

eliminates leaks and lets you watch frothing
process. It is also magnetized to store un-used
attachment.

2. Double-Walled Housing

stays cool to the touch when
frothing hot milk

3. Hot Milk Button

is used to froth hot milk
or warm up milk

4. Cold Milk Button

lets you froth cold milk

5. Milk Frothing Whisk

aerates milk to create
creamy foam

6. Milk Warming Stirrer

stirs milk as it heats
to prevent burning

7. Froth Spoon

makes it easy to scoop
out froth

8. Detachable Cord

for easier storage

9. BPA-Free (not shown)

parts include everything that
comes into contact with food

1

2

3
4

5

6

7

8

BEFORE THE FIRST USE

Carefully unpack the unit and remove any packaging
and promotional labels in or on the milk frother.
Rinse all accessories thoroughly in warm soapy water
and then dry completely.

4

OPERATING INSTRUCTIONS

Frothing Milk

1. Remove the cover and insert the milk
frothing whisk in the recess in the bottom
of the housing.

2. Fill the tank with the desired amount of milk.

Note: Never fill milk over the MAX fill line.
Frothed milk expands and it will overflow
the tank if the level is too high.

3. Put the cover back on the tank.

4.

Start frothing by pressing the corresponding
Milk Button (top position button for HOT and bottom
position button for COLD). The LED light will be
illuminated during operation.

Note: Preparation stops automatically after 2 minutes,

depending on the amount of milk.

5. Open the cover after frothing is complete.

6.

Pour or ladle the milk froth into a cup or
glass.

7. After using the unit, clean it as described
in the Cleaning and Maintenance section,
next page.
Note: Wait for tank to cool before cleaning.

Warming Milk

1. Remove the cover and insert the milk
warming stirrer.

2. Fill the tank with the desired amount of
milk.

Note: Never fill milk over the MAX fill line.

3. Put the cover back on the tank.

4. Start warming milk by pressing the
corresponding Hot Milk Button (top
position). The LED light will be illuminated
during operation.

Note: Preparation stops automatically after 2 minutes,

depending on the amount of milk.

5. Open the cover after warming is complete.

6. Pour the warmed milk into a cup or glass.

7. After using the unit, clean it as described in the
Cleaning and Maintenance section, next page.
Note: Wait for tank to cool before cleaning.

5

CLEANING AND MAINTENANCE

Always make sure the appliance is unplugged before you
start cleaning it.

1. Clean the exterior of the unit with a soft, moist cloth.
If heavily soiled, a mild detergent can be used.

2. Remove the whisk or stirrer from tank and rinse them
with soap under warm running water. Seal on cover
can also be removed and rinsed under warm, soapy
water.

3. Clean out the tank with hot water and a soft cloth after
use. If the tank is still soiled, wash using a soap
solution and rinse thoroughly. Use a soft cloth to
prevent damaging the nonstick coating.

CAUTION: Never submerge the base, the power cord

or plugs in water or other liquids.

4. Any service other than cleaning and normal user
maintenance should be performed by an authorized
Cuisinart Service Representative.

TROUBLESHOOTING

Q: Why are LED lights not illuminating after I push

the corresponding button?

A: The plug is not plugged in. Make sure plug is placed

correctly in the socket.

A: Temperature monitoring has been triggered. Let the

unit cool for 5 minutes.

A: Filling level was too high. Reduce the amount of milk

in the tank.

Q: Why is milk leaking from around the cover?

A: The seal ring is missing or dirty. Clean the seal ring and

replace.

A: The cover is not placed correctly over the milk tank.
Put the cover on so that it is flush with the tank and the
seal is not showing.

Q: Why is the milk froth not coming out the way I want?

A: The wrong attachment may be in place in the milk tank.
Double check and make sure the milk frothing whisk
is inserted in the tank correctly.

6