Cuisinart DCC-1100 Quick Reference

QUICK REFERENCE GUIDE

Setup and uSe

Fully immerse the charcoal water filter in
cold tap water and soak for 15 minutes (see

1.

3.

complete instructions on page 8 of your

instruction booklet). Insert the filter into the
water filter holder. Open the water reservoir and place
filter holder into the unit.

Insert the permanent gold tone filter or
paper filter into the filter basket holder.
Using the scoop provided, add 1 scoop of
ground coffee per cup - you can adjust the
amount to taste. Close the lid.

2.

4.

Pour desired amount of water into the
water reservoir. A water level indicator is
located on the side of the unit.

Check to make sure the filter basket is
securely in place and lid is completely
closed.

To brew coffee, turn the Function Knob to
the Brew position. Then press the On/Off
button and release. The red ON indicator

5.

light will illuminate and brewing will begin.

Please see reverse side for programming instructions.

IMPORTANT!

Do not throw away. Read before

operating your new coffeemaker.

Keep for further reference.

These helpful hints are intended

to be a supplement to the instruction
booklet. In order to ensure proper operation
and optimum performance, please read the

entire instruction booklet.

QUICK REFERENCE GUIDE

programming

To set the time: Turn the Function
Knob to Clock. Press and hold the Hour or

1.

3.

Minute button until the clock begins flashing.

Hold down the Hour or Minute button to
scroll through the numbers. When desired time
approaches, release the button and press repeatedly
to advance one digit at a time. To finish, wait for the
numbers to stop flashing.

At the programmed time, the red ON

indicator light will come on, indicating that

the brew cycle is starting.

To program the Auto On:
Turn the Function Knob to PROG; the AUTO

2.

time” instructions). Once complete, turn the Function
knob to AUTO ON and press the On/Off button and
release. The green indicator light will come on to
remind you that the programming function is in use.

4.

ON LED will flash. Set the time you want
coffee to begin brewing (follow “set the

To start the brew cycle at the same time
the next day, simply press the On/Off
button and release. The green indicator
light will illuminate.

5.

To program the Auto Off: Turn the

Function Knob to Auto Off. Use the Hour and

Minute buttons as in #1 (to set the time) to

program your coffeemaker to shut off from

0 to 4 hours after brew cycle is finished.

Please see reverse side for setup and use instructions.

12-Cup Classic Programmable

Coffeemaker

PG-26829