Cubot S1 User Manual

User manual

Model: CUBOT S1

Brand: CUBOT

Charger wire

CUBOT S1 Smart Bracelet

 Product activation (first usage)

1. For first usage, make the thimble of the charger wire contact the bracelet end with a
contact, and insert the USB into a charger, mobile phone or computer for activation.

2. The bracelet will display the interface below after it is successfully activated

Ulna

 Wear the bracelet

1) Wear the bracelet on your wrist. If you wear it all day long, you are suggested to
wear it at the place one finger wide below your ulna.

2) If you intend to accurately measure your heart rate by using any S1 bracelet, you
may shift the bracelet to your upper wrist, namely the place three fingers wide below
your ulna. The bottom heart rate sensor shall cling to your skin and movement shall be
avoided. Do not wear the bracelet too tight, otherwise blood circulation will be affected,

which affects correct heart rate signals.

Touch

1.The bracelet will be lightened by touching its screen, and all functional interfaces can
be viewed by sliding horizontally.

2. All functional interface displays

Time,
date,

battery

level

Atmospheric
pressure,
temperature,
elevation display

UV light

display

Music

control

Heart

rate

Main

interface

of exercise

 APP download and installation

1. Make sure that your mobile phone is connected to mobile Internet or WLAN;

2. Scan the QR codes below or visit various APP stores to download and install
“CUBOT S1” APP (iPhone users may search and download it at APP Store, Android
users may search and download it at the Play Shop of Google Play).

 Bracelet binding and data synchronization

1. Bracelet binding, unbinding and Bluetooth disconnection

1) First bracelet binding: Enable the Bluetooth of your mobile phone to start the S1
bracelet APP; the APP will go to the exercise interface after a successful binding is

finished. And a Bluetooth icon will appear on the time interface of the bracelet;

2) In case you have bound any smart bracelet and need to bind another S1 bracelet,
you shall unbind other bracelet before binding any S1 bracelet. Press the button
on the APP to pop up a sidebar. Click “Setup management” menu to enter the device
management interface. Click “My device” to pop up the device selection interface.

3) The bracelet will automatically disconnect if it is out of the effective range of the
Bluetooth of your mobile phone. It will automatically connect the APP after it is
disconnected due to non-manual disconnection and it is in effective Bluetooth range
again.

4) You may turn off the Bluetooth on the APP, and the bracelet will disconnect with the
Bluetooth. The bracelet will connect the APP automatically after the Bluetooth is turned
on again.

2. Data synchronization

1)After the binding is successful, the bracelet will have automatic data synchronization
with the APP. The bracelet time will be calibrated automatically, and data
synchronization will be performed automatically when the APP is started each time;

2) You may also have manual data synchronization on the APP. Manual data
synchronization can be performed by pulling down the relevant page on the exercise,
sleeping or heart rate interfaces. (Normal connection between the bracelet and mobile
phone Bluetooth shall be guaranteed during data synchronization)