CUB ELECPARTS VS61U009 User Manual

User manual of Uni TPMS Sensor VS-61U009

Installation Instructions

After you have programmed the Uni-Sensor, follow installation procedures below.

Important:

Each time the TPMS sensor is changed or disassembled, it is MANDATORY to replace

the TPMS sensor washer, nut, screw, and valve core accessories (use only CUB service

component kits designed for TPMS sensor) to ensure proper sealing.

For Clamp-In Metal Valve Sensors:

1. Insert valve stem grommet onto stem

with largest diameter again valve

stem body.

2. Place valve stem into sensor. Loosely

screw into place so sensor drop angle

For Rubber Snap-In Valve Sensors:

Avoid wet and extreme temperatures.

Never install a used screw or used Snapin

Valve.

1. Apply tire soap or lube solution to

rubber valve stem.

2. Line sensor up with rim hole and

can be adjusted.

3. Insert assembled sensor & valve stem

into wheel. Hold in place by hand.

4. From outside wheel, put on white

seal, then metal washer, then valve

stem nut (or metal nut combination

with washer). While holding sensor

down against wheel bottom, hand

tighten nut. With torque wrench,

tighten Valve Stem Nut to 4.0Nm.

5. Holding sensor down against wheel

bottom, with torque wrench, tighten

valve stem screw to 2.0Nm.

6. Double check all work.

attach a standard TTV pull tool to the

end of the valve.

3. Pull the valve stem straight through

the valve hole. Refer to your TTV tool

manual for proper installation. Force

to seat shall not exceed 40kg(90lb).

4. Refer to your tire changing

equipment manuals for proper

instructions for mounting tire to rim

when snap-in TPMS sensors are used.

5. Prohibited use for racing and beyond

180 km/h (110mph).

6. Tighten the screw by 12 lbf-in if

necessary to reinstall the valve.

Caution:

It is recommended to seek the service of a qualified technician. Pay special attention

and follow all instructions to all cautions and warnings included in the shop manual.

Failure to do so could result in failure of the vehicle’s Tire Pressure Monitor System

(TPMS) Sensors to function properly, or result in damage to the TPMS Sensor.

The PUR-sensor(Uni-Sensor) is blank software inside, be sure to program the sensor

by CUB’s sensor-AID or compatible tool for your specific motor vehicle make, model

and year before installation. Only install programmed TPMS sensors to the application

listed in the tool. Improper TPMS installation or the use of unauthorized TPMS Sensors

will cause the failure of TPM system. Upon completion of installation, test the TPMS

System following the original manufacturer’s service guide to confirm proper

installation. Check all installation procedures to ensure proper installation and retest.

If the System continues to fail consult with CUB support or an authorized motor vehicle

dealership.

These TPMS sensor assemblies are designed and manufactured to be operated in

Original Equipment wheels and tires only. While using non-OE wheels/tires, the vehicle

owner has responsibility to ensure that the TPMS is working correctly. Failure to ensure

that the TPMS is working correctly can result in severe injury or death.

Warranty:

CUB warrants that the TPMS sensor shall be free from defects in workmanship and

material during warranty period. CUB does not assume any liability in case of faulty,

incorrect installation of the product, or by using other products causing TPMS sensor

malfunction on the part of customer or user.

Always check our website for detail installation procedures, safety information and

warranty policy.

http://www.cubautoparts.com/download.php?id=17