CRU Ditto Forensic FieldStation User Manual
Wiebetech Branding
© 2015 CRU Acquisition Group LLC, ALL RIGHTS RESERVED. CRU®, Ditto®, and WiebeTech® are
trademarks of CRU Acquisition Group, LLC and are protected by trademark law.
Product Warranty
CRU warrants this product to be free of signicant defects in material and workmanship for a period
of three years from the original date of purchase. CRU’s warranty is nontransferable and is limited
to the original purchaser.
Limitation of Liability
The warranties set forth in this agreement replace all other warranties. CRU expressly disclaims all
other warranties, including but not limited to, the implied warranties of merchantability and tness
for a particular purpose and non-infringement of third-party rights with respect to the documenta-
tion and hardware. No CRU dealer, agent, or employee is authorized to make any modication,
extension, or addition to this warranty. In no event will CRU or its suppliers be liable for any costs of
procurement of substitute products or services, lost prots, loss of information or data, computer
malfunction, or any other special, indirect, consequential, or incidental damages arising in any way
out of the sale of, use of, or inability to use any CRU product or service, even if CRU has been
advised of the possibility of such damages. In no case shall CRU’s liability exceed the actual money
paid for the products at issue. CRU reserves the right to make modications and additions to this
product without notice or taking on additional liability.
FCC Compliance Statement: “This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired
operation.”
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at this own expense.
In the event that you experience Radio Frequency Interference, you should take the following steps
to resolve the problem:
1) Ensure that the case of your attached drive is grounded.
2) Use a data cable with RFI reducing ferrites on each end.
3) Use a power supply with an RFI reducing ferrite approximately 5 inches from the DC plug.
4) Reorient or relocate the receiving antenna.
FOR OFFICE OR COMMERCIAL USE
Protecting Your Digital Assets
TM
CRU® WiebeTech®
Ditto® FireWire 800 Expansion Module
Quick Start Guide
Features
• Adds FireWire 800 functionality to the Ditto Forensic FieldStation
• Quickly connects and starts working without software
• Provides up to 800 Mbps write-blocked access to FireWire external enclosures
• Supports USB external enclosures via USB 2.0
Part Number: A9-000-0028-4 Rev. 1.2
CRU WiebeTech Ditto FireWire 800 Expansion Module Quick Start Guide
CRU Mark
2
CRU WiebeTech Ditto FireWire 800 Expansion Module Quick Start Guide
3
1 INSTALLATION
Expansion modules connect to the Ditto through a designated port on the Source Input side of
the unit.
Ensure that you have upgraded your Ditto Forensic FieldStation’s rmware to “2015Mar12a”
or newer. Follow the instructions for upgrading rmware in the Ditto Forensic FieldStation User
Manual in order to do so.
Once your rmware is upgraded, you are now ready to use the Ditto FireWire 800 Expansion
Module!
2 TECHNICAL SPECIFICATIONS
Product Models Ditto FireWire 800 Expansion Module
Interface Types & Speeds FireWire 400: up to 400 Mbps
FireWire 800: up to 800 Mbps
USB 2.0: up to 280 Mbps
Drive Types Supported Enclosures with FireWire 400, FireWire 800, and USB connections
Operating Humidity 5% to 95%, non-condensing
Compliance EMI Standard: FCC Part 15 Class A, CE
EMC Standard: EN55022, EN55024
RCM
External Material All-alluminum construction
Product Weight 0.4 pounds (.185 kg)
Product Dimensions 4.95” x 2.81” x 1.43” (126mm x 71mm x 36mm)
Technical Support Your investment in CRU products is backed up by our free techni-
cal support for the lifetime of the product. Contact us through
our website, cru-inc.com/support or call us at 1-800-260-9800 or
+1-360-816-1800.
Protecting Your Digital Assets
TM
Loading...